Electrolux 318201778 Range Installation, Excessive Weight Hazard Check Operation

36" GAS RANGE INSTALLATION INSTRUCTIONS

6.Range Installation

1.The back of the range may be installed directly against the wall.

2.To reduce possible scorching of vertical walls and to minimize potential fire hazards under abnormal surface unit use conditions such as high heat or no pans and to conform to Agency requirements:

-A minimum of 7" (17.8 cm) spacing should be provided on both sides of the cooktop.

Excessive Weight Hazard

6.2Check Operation

Refer to the Use and Care Guide and the Electronic Oven Control Guide packaged with the range for operating instructions and for care and cleaning of your range.

Remove all packaging from the oven before testing.

1. Burner Bases and Burner Caps

This range is equipped with sealed burners as shown (Figure 7). All pieces are at their place. Take note where they are. Remove all packaging material located under the Dual Surface burner head. Make sure the burner is properly aligned and leveled. NOTE: There are no burner adjustments necessary on this range.

•Use 2 or more people to move and install range.

•Failure to follow this instruction can result in back or other injury.

6.1Leveling the Range

1.	Install an oven rack in the center of the oven.
2.	Place a level on the rack (see Figure 6). Take 2
	readings with the level placed diagonally in one
	direction and then the other. Level the range, if
	necessary, by adjusting the 4 leveling legs with a
	wrench (see Figure 11).
3.	Slide the range to its final position and double check

Burner Cap

Fixed Burner Ring

and Burner Base

Regular Burner Figure 7

Burner Cap

Burner Base

Fixed Burner Ring

Dual Surface

Burner

for levelness. If the range is not level, pull unit out

and readjust leveling legs, or make sure floor is

level.

Figure 6

2.Turn on Electrical Power and Open Main Shutoff Gas Valve

3.Check the Igniters

Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper lighting: a.Push in and turn a surface burner knob to the LITE

position. All electronic surface ignitors will spark at the same time. However, only the burner you are turning on will ignite.

b.The surface burner should light once the flow of gas reached the surface burner. Each burner should light within four (4) seconds in normal operation after air has been purged from supply lines. Visually check that burner has lit.

c. Once the burner lights, the control knob should be rotated out of the LITE position.

There are separate ignition devices for each burner. Try each knob separately until all burner valves have been checked.

6