Frigidaire FFGF3017LB Setting Surface Controls, Setting surface controls, Setting surface burners

Setting surface controls

Your gas appliance may be equipped with different sized surface burners. The ability to heat food quicker and in larger volumes increases as the burner size increases. It is important to select cookware that is suitable for the amount and type of food being prepared.

The smaller simmer burner (some models) is best suited for simmering delicate sauces, etc.

The standard size (9,500 BTU) burners may be used for most surface cooking needs.

The larger (quick boil - some models) burner or burners are best used for bringing large quantities of liquid to temperature or when preparing larger quantities of food.

Setting surface burners

1.Place cooking utensil on center of surface burner grate. Make sure the utensil is centered and stable on the grate.

2.Push the desired surface control knob in and turn counterclockwise out of the OFF position (Fig. 1).

3.Release the knob and rotate to the LITE position. Visually check that the gas burner has lit.

4.Push the control knob in and turn counterclockwise to the desired flame size. Use the control knob markings and adjust the flame as needed.

CAUTION

Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on the cooktop when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the range cooktop.

NOTES

DO NOT cook with the surface control knob in the LITE position. The electronic ignitor will continue to spark if the control knob is left in the LITE position.

When setting any surface control knob to the LITE position, all electronic surface ignitors will spark at the same time. However, only the surface burner you are setting will ignite.

SETTING SURFACE CONTROLS

Fig. 1

IMPORTANT

•NEVER place or straddle a cooking utensil over 2 different surface cooking areas at the same time.

•Do not place aluminum foil, or ANY material that can melt on the range cooktop. If these items melt they may permanently damage the cooktop surface.

•In the event of an electrical power outage, the surface burners can be lit manually. Use caution when lighting surface burners manually. To light a surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE. After burner lights push in and turn knob to desired setting.

Home Canning

Be sure to read and observe all the following points when home canning with your appliance. Check with the USDA (United States Department of Agriculture) website and be sure to read all the information they have available as well as follow their recommendations for home canning procedures.

•Use only quality flat bottom canners when home canning. Use a straight-edge to check canner bottom.

•Use only a completely flat bottom canner with no ridges that radiate from the bottom center when home canning using a ceramic cooktop.

•Make sure the diameter of the canner does not exceed 1 inch beyond the surface element markings or burner. It is recommended to use smaller diameter canners on electric coil and ceramic glass cooktops.

•Start with hot tap water to bring water to boil more quickly.

•Use the highest heat setting when first bringing the water to a boil. Once boiling is achieved, reduce heat to lowest possible setting to maintain that boil.

9