Frigidaire 318200880 manual Setting Surface Controls, Sizes of the Surface Gas Burners

Setting Surface Controls

Sizes of the Surface Gas Burners

Your appliance is supplied with the 4 different surface gas burners:

•1 Simmer Burner (5,000 BTU)

•1 or 2 Standard Burners (9,500 BTU)

•1 Power Burner (12,000 BTU)

•1 Power Burner (14,000 BTU)

When setting up the range for the first time, make sure that the correct Burner Heads, Burner Caps and Burner Grates are located as shown in Figure 1.

Grate

Pin

Burner
Grate
Burner
Cap
Burner	Cap Pilot
Head	Hole
	Electrode
	Orifice
	Holder

Electrode must be located properly in slot of each Burner Head

Figure 2

Removable

Flue Covers

Inner Vent

Cover

Figure 3

Burner Cap (Standard or Extra Large)

		Standard or “POWER” Burner Head
Burner Cap		(9,500 BTU) or (12,000 BTU)
(Standard)		Left Rear
		Orifice	Small Burner Cap
Standard		Holder
Burner Head
(9,500 BTU)	Extra Large		“SIMMER”
Left Front
	Burner Cap		Burner Head
Orifice Holder			(5,000 BTU)
	“POWER”		Right Rear
	Burner Head
			Orifice Holder
	(12,000 BTU)
	or (14,000 BTU)

Right Front

Orifice Holder

Figure 1

Assembly of the Surface Burner Heads, Burner Caps, Burner Grates and Flue Covers

It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations.

1.Place all 4 Burner Heads in the correct locations (See Figure 1). Make sure that the correct Burner Head is placed with the corresponding Orifice Holder and that the Electrode is located properly in the slot of each Burner Head (See Figure 2). Proper Burner Head placement insures that each Burner will have the correct spark required for surface gas ignition.

2.Place the correct Burner Caps at each of the burner locations (Burner Cap Pilot Hole must face up). Each of the 4 (four) Burner Heads MUST have a Burner Cap installed to insure proper ignition and gas flame size and must be in place with the Pilot Hole facing up BEFORE placing the Burner Grates (See Figure 2).

3.Place the 2 (two) cast iron Burner Grates supplied with the range. Carefully lineup the 2 Grate Pins on each Grate with the Cap Pilot Holes in the 2 Burner Caps on each side of the range. DO NOT force the Burner Grates onto the Burner Caps. Forcing the grates down onto improperly installed Burner Heads and Burner Caps may damage the gas burners. Each Burner Cap is designed with a Cap Pilot Hole in the top center of the Cap. Visually check that ALL the Grate Pins line up into the Burner Cap Pilot Holes (See Figure 2). Properly installed Burner Grates will rest with all four Grate legs on the glass cooktop.

4.Place the 2 (two) flue covers over the inner vent cover as shown on figure 3.

REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS

OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use.

8