Frigidaire 318200407 manual Oven Light, Surface Light

Page 7

Installation Instructions (continued)

UNLOCK

LOCK

LOCKING THE FRONT ROLLERS (some of the 30” models only)

Oven Light

To level the range:

1.Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four leveling legs two to three turns each.

2.Install an oven rack in the center of the oven.

3.Move the range to its final position, then put a spirit level on the rack to check for levelness. Take two readings, one with the level placed diagonally first in one direction, and then the other.

4.Use the 1-1/4” key or wrench to adjust the leveling legs. Turn each one until the range stands firm without wobbling.

5.Some models are supported by smooth glide rollers to facilitate moving.

If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to prevent the range from moving.

If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling legs to level, support and prevent the range from moving.

Do not turn the oven light on during the self-cleaning cycle.

High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven door is opened.

The oven light may be turned on when the door is closed by using the oven light switch located on or underneath the control panel.

On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.

THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE OVEN IS COOL.

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with a 40 watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

Surface Light

(some models)

BESUREALLSURFACEELEMENTCONTROLKNOBSARETURNEDTOOFF“ ”

ANDELEMENTSARECOOL.

Use switch located on or underneath the control panel to turn the surface light ON/OFF.

Replace the surface light, if after repeated attempts to turn it on you are not successful.

SURFACE LIGHT REPLACEMENT (some models)

To remove and replace the fluorescent light:

1.Place your fingers under the tube at approx. 8” (20.3 cm) from each end.

2.To remove, turn the tube 90° then pull it down and out of its sockets.

3.To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place. Turn on the surface light to make sure it will lit.

General 7 Information

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Electric Ranges N e r ’ s I d e Register Your Product Product RegistrationProduct Registration Important Safety Instructions SELF-CLEANING Ovens Important Instructions for Using Your CooktopImportant Instructions for Cleaning Your Range Important Instructions for Using Your OvenLeveling Installation InstructionsClearances and Dimensions LocationSurface Light Oven LightGood Setting Surface ControlsCircuit Protection Selecting Surface Cooking UtensilsConvection notes Convection Roasting some modelsAir Circulation in the Oven Convection CookingBaking Problems and Solutions Chart Indicator LightOven Baking Broiling Oven SettingsTypes of Heating Units Used Ceramic Glass Cooktop some modelsCeramic Glass Cooktop some models HOT Surface Indicator LightSome models Things to Remember Special Caution for Aluminum Foil Aluminum Cooking UtensilsUSE and Care of Glass Surface Do USE on Ceramic Glass Cooktop Cleaning Materials for Ceramic Glass CooktopDo not USE on Ceramic Glass Cooktop Coil Surface Elements some models Cleaning the ApplianceSurfaces Cleaning Agents Instructions Control PanelPorcelain Enamel Cooktop Cleaning Porcelain enamel cooktop cleaning instructionsDaily Cleaning Adhere to the following cleaning precautions Cleaning the Regular Oven Non self-clean ovenCleaning the Self-Clean Oven some models Preparing the Oven for Self-CleaningAutomatic Lock OFF of the Surface Elements What to Expect During CleaningSetting the Controls for a Clean Cycle To Remove and Replace the Oven DoorTo replace the external door panel Removable Outer Door Glass Panel some modelsTo Remove/Replace Storage Drawer To remove the external door glass panelGeneral 21 Information Staple or clip original invoice here Problem Possible Cause / Solution Avoid Service Check ListSurface Units Poor Baking Results Avoid Transportation Damage to Your Range BroilingIf YOU Need Service Multiflex Range WarrantyMultiflex Smoothtop Range Warranty

318200407 specifications

The Frigidaire 318200407 is a high-quality range surface burner knob, designed specifically for several model ranges. This genuine replacement part enhances both the functionality and precision of your cooking experience. One of the foremost features of the Frigidaire 318200407 is its durable construction, crafted to withstand the rigors of daily use in a busy kitchen. The knob is built from high-grade plastic, ensuring it can endure high temperatures, making it ideal for range cooktops.

One of the standout technologies associated with the Frigidaire 318200407 is its user-friendly design. The knob features a clearly visible dial, making it easy for users to read and operate. The simple yet effective design allows for precise temperature adjustments, granting home cooks better control over their culinary creations. This is particularly important when preparing delicate dishes that require specific heat levels.

Another characteristic of the Frigidaire 318200407 knob is its ease of installation. Homeowners and DIY enthusiasts will appreciate the straightforward process of replacing a broken or worn-out knob without needing any professional assistance. It typically fits easily onto compatible ranges and requires no special tools or equipment for installation, making it accessible for everyone.

Maintenance is also hassle-free, as the knob can be easily cleaned with a mild detergent and a soft cloth. This ensures that your kitchen remains not only functional but also visually appealing. The Frigidaire 318200407 is often praised for its sleek design, which complements modern kitchen aesthetics while maintaining a classic touch.

In terms of compatibility, the Frigidaire 318200407 is designed to fit various models, making it a versatile choice for those with different Frigidaire range appliances. This means that whether you have a gas or electric range, this knob can likely serve as a reliable replacement.

Overall, the Frigidaire 318200407 surface burner knob combines durability, ease of use, and compatibility with various models, making it a crucial component for restoring the functionality of your Frigidaire range. With its thoughtful design and technology, this product ensures an enhanced cooking experience, allowing for delicious meals with confidence and ease.
Top Page Image Contents