Slide-In Ranges
FGGS3065K F/ W/ B 30" Gas
Slide-In Range Specifications
•Product Shipping Weight (approx.) – 250 Lbs.
•Voltage Rating – 120V / 60 Hz / 15 Amps
•Connected Load (kW Rating) @ 120 Volts = 1.2 kW
(For use on adequately wired 120V, dedicated circuit having
•Amps @ 120V = 10 Amps
•Always consult local and national electric and gas codes.
•Make sure wall coverings around range can withstand heat generated by range.
•Linoleum or any other synthetic floor covering located beneath range, must be capable of withstanding minimum heat of 90° F above room temperature without shrinking, warping or discoloring. Insulating pad or
•Do not obstruct flow of combustion air at oven vent nor around base or beneath lower front panel of range. Range requires fresh air for proper burner combustion.
•Range ships with 3/4" factory regulator.
•LP Gas conversion kit supplied.
•Gas supply piping can be routed through side wall of right cabinet. Right side cabinet is ideal location for main shutoff valve.
•Countertop MUST be level in all directions and adjustable range height at least 1/16" greater than tallest cabinet height, to ensure metal rangetop flange will fit properly on countertop edge.
•When installing optional Backguard Kit, cutout depth of
•Overhead cabinetry should not exceed a 13" maximum depth.
•Absolute minimum horizontal distance between overhead cabinets installed to either side of appliance must be no less than maximum width of appliance.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 •
•Allow 24" minimum clearance between rangetop and bottom of cabinet when bottom of wood or metal cabinet is protected by not less than 1/4"
•Allow 5" minimum clearance from edge of rangetop to nearest combustible wall on either side of unit.
•To reduce risk of fire when using overhead cabinetry, install range hood that projects horizontally a recommended minimum of 5" beyond bottom of cabinets.
Countertop Preparation
For detailed preparation instructions, refer to installation guide on the web.
•Flat
•Formed
•Tile countertops may need cut back 3/4" from each front corner of opening and /or rounded edge flattened.
•For existing cutout width greater than
Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.
Optional Accessories
•Rear Filler Kit: White – (PN # 901193-9011), Black – (PN # 901193-9010).
•Side Panel Kit: White – (PN #
•Backguard Kit: White – (PN #
•Side Trim Kit: White – (PN # 903075-9011), Black – (PN # 903075-9010).
Accessories information available | Specifications |
on the web at frigidaire.com | subject to change. |
FGGS3065K 02/11 | © 2011 Electrolux Home Products, Inc. | Printed in the U.S.A. |