3-Inch Side Panel Kit
STEP 4: Hold the left side panel in position on the side of the range. Locate the center mounting hole. Remove and retain the screw attached to the chassis beneath it.
STEP 5: Insert the tabs on the trim piece into the slots on the range.
Hex screw 
Side Panel 
Hex screw 
Hex screw 
Front Panel
Torx screw
Torx screw
STEP 6: Use the hex head screw (83023) removed from the side, a Torx head screw removed from the kick panel and the hex screws from the kit to attach the side panel to the range. Three
(3)hex head screws attach the side. One (1) Torx head screw (83709) inserts through the end cap hole to attach the top of the side panel. One (1) Torx head screw (83709) inserts through a hole in the front panel to attach the bottom of the side panel.
STEP 7: Reinstall the end cap.
STEP 8: Repeat steps 3 to 7 for the right side panel. NOTE: There is an additional hex screw (83023) in the kit for the right side panel because the center mount- ing screw is not reused as with the left side (do not perform step 4).
STEP 9: Reattach the kick panel to the range by snapping the ball studs on the back of the panel into the holes on the front panel of the range. Open the door and reattach the kick panel top screws removed in step 1.
Space between door and oven opening
Reattach screws
Kick Panel
Page