GE EER3002 Cleaning Operating Instructions Safety, Consumer Support Troubleshooting Tips Care

Page 20

Instructions

Care and cleaning of the range.

Cleaning Operating Instructions Safety

The gasket is designed with a gap at the bottom to allow for proper air circulation.

Do not rub or clean the door gasket— it has an extremely low resistance to abrasion.

If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

Cleaning the Oven Door

To clean the inside of the door:

■Because the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand.

■The area outside the gasket and the door liner can be cleaned with a soap-filled steel wool or plastic pad, hot water and detergent. Rinse well with a vinegar and water solution.

To clean the outside of the door:

■Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door. Do not let water drip into the vent openings.

■If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a sponge-scrubber for best results.

■Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.

■Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.

Lift-Off Oven Door

Consumer Support Troubleshooting Tips Care and

Slot

Hinge lock

Pull hinge locks down to unlock.

Removal position

The door is very heavy. Be careful when removing and lifting the door.

Do not lift the door by the handle.

To remove the door:

Fully open the door.

Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat-blade screwdriver, may be required.

Firmly grasp both sides of the door at the top.

Close door to the door removal position, which is halfway between the broil stop position and fully closed.

Lift door up and out until the hinge arm is clear of the slot.

To replace the door:

Firmly grasp both sides of the door at the top.

With the

Bottom

Hinge arm

door at the

edge

 

same angle as

of slot

 

the removal

 

 

position, seat the

 

indentation of

 

Indentation

the hinge arm

 

 

into the bottom

 

edge of the hinge slot. The notch in

the hinge arm must be fully seated

into the bottom of the slot.

Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.

Push the hinge locks up against the front frame of the oven cavity to the locked position.

Hinge arm

Hinge lock

Push hinge locks up to lock.

Close the oven door.

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 164D4290P319 Write the model and serial numbers here Model # Serial #All ranges can tip and injury could result Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.comSafety Instructions Cook Meat and Poultry THOROUGHLY…Radiant Surface Units Tips Care Consumer SupportUsing the surface units SafetyCare and Cleaning Troubleshooting Tips Consumer Support How to SetConsumer Support Troubleshooting Temperature LimiterInstructions About the radiant surface units…Selecting types of cookware Tips Consumer SupportUsing the oven controls CleaningConsumer Support Troubleshooting Tips CareCare Using the ovenConsumer Support How to Set the Oven for Broiling SafetyBroiling Guide InstructionsInstructions Using the clock and timerCare and Cleaning Using the timed baking and roasting features Safety InstructionsHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopUsing the Sabbath Feature Safety InstructionsCleaning Troubleshooting Operating InstructionsAdjust the oven thermostat-Do it yourself Consumer Support Troubleshooting Tips CareTo Adjust the Thermostat Type of margarine will affect baking performanceUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning Instructions Operating InstructionsAfter a Clean Cycle Consumer Support Troubleshooting TipsHow to Delay the Start of Cleaning Care and cleaning of the range Care and CleaningCleaning Operating Instructions Safety Consumer Support Troubleshooting Tips CareCleaning the Oven Door Lift-Off Oven DoorPainted Surfaces Oven VentOven Shelves Oven vent is located behind the right rear surface unitOperating Instructions Safety Tips Care and CleaningOven Light Replacement Broiler Pan & GridCleaning the glass cooktop Normal Daily Use CleaningBurned-On Residue Heavy, Burned-On ResidueGlass surface-potential for permanent damage Instructions SafetyCleaning Operating Before you call for service… Problem Possible Causes What To DoSee the Adjust the oven thermostat-Do it yourself Oven temperatureOven light does Oven will not workPower outage During a clean cycleNot unlock Clean light flashes Clock flashesOven not clean after Clean cycleClean light is on On when range is notWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration GE Electric Range Warranty Troubleshooting Tips Consumer SupportSafety Instructions Operating Instructions GE Will ProvideSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio

EER3002 specifications

The GE EER3002 is an advanced, energy-efficient air conditioner that delivers optimal performance and comfort in both residential and commercial settings. With its innovative design and cutting-edge technology, the EER3002 has gained popularity as a reliable cooling solution for numerous customers seeking to enhance their indoor environment.

One of the standout features of the GE EER3002 is its high energy efficiency rating. It is designed to provide effective cooling while minimizing energy consumption, making it an environmentally friendly option that can also help reduce utility bills. The unit is equipped with an efficient compressor that operates quietly, ensuring a peaceful atmosphere in your home or workplace.

The GE EER3002 utilizes advanced refrigerant technology, which not only enhances cooling performance but also complies with evolving environmental standards. By employing eco-friendly refrigerants, the unit not only cools effectively but also reduces its overall carbon footprint. This commitment to sustainability is an essential characteristic that sets the GE EER3002 apart from many other air conditioning units on the market.

Additionally, the GE EER3002 features a user-friendly digital thermostat, allowing for precise temperature control and easy programming. Homeowners and businesses can set their desired cooling levels, and the unit will maintain the temperature efficiently. The programmable options elevate convenience, enabling users to adjust settings according to their schedules.

Another important aspect of this air conditioner is its versatile installation options. The GE EER3002 can be installed in a window or through a wall, ensuring flexibility in placement while still offering powerful cooling capabilities. Its compact size is designed for easy installation, allowing customers to have it up and running in no time.

The build quality of the GE EER3002 also deserves mention. It is constructed with durable materials that can withstand varying weather conditions without compromising performance. Furthermore, the air conditioner includes accessible filters, making maintenance straightforward and ensuring consistent air quality within the space.

In summary, the GE EER3002 combines energy efficiency, advanced refrigerant technology, user-friendly controls, flexible installation options, and robust build quality. These features make it an excellent choice for anyone seeking a reliable air conditioning solution that offers both performance and longevity in their cooling needs. Whether for residential or commercial use, the GE EER3002 is engineered to deliver a comfortable and pleasant indoor climate all year round.
Top Page Image Contents