GE JBP79 installation instructions Electrical Connections oot, THREE-WIRE Cord Connection KIT

Installation Instructions

Electrical Connections oo°t.

THREE-WIRE		CORD	CONNECTION		KIT	Connect	the	outer wires to the outside
						terminals and the center wire to the
					Grounded	center terminal. Do not remove the
						ground	strap
Complete		3	3	_>_._ _	Neutral			Grounded
			Screws _]_		Terminal
wire	cord	kit.	l					Neutral
				/_White)
								(White)
by step					sSt rraPw
instructions		on
how	to install					Outer
the	kit.			Connection	Relief	Wire
						,
				Plate	Clamp
						Wire		Outer

I-_ Remove the screws on the terminal block with a

Wi re

1/4" nut driver or phillips screwdriver.

Knockout in center of connection plate may be taken out

Install the three-wire				3 wire
cord	and strain		_r_	cord kit
			Connection _. ,_._
relief	through the
hole	in the		Pla_
connection		plate,	-_	] Strain
				Relief

Clamp

F_a--i Push the cord upward (to relieve strain), while tightening the strain relief clamp.

i-_a--i Re-install the wire cover with the 5 screws removed earlier. Make sure the

wires do not become pinched between the wire cover and mainback.

!

I

iWire

Cover

Special note: If local codes require an undgrounded neutral, you must do the

following:

a. Remove ground strap.

b. Fasten the white wire to the center terminal.

c. Use grounding terminal or lead to ground unit in accordance with local codes.

7