GE JSP39 Instructions Care and Cleaning, Troubleshooting Tips Consumer, Control Lockout

www.GEAppliances.com

Oven Control, Clock and Timer Features and Settings

Safety

AUTOMATIC OVEN Light

This lights anytime the oven has been programmed using the COOKING TIME or DELAY START functions.

– Pad

Short taps to this pad will decrease the time or temperature by small amounts. Touch and hold the pad to decrease the time or temperature by larger amounts.

CLEAR/OFF Pad

Touch this pad to cancel ALL oven operations except the clock and timer.

BROIL HI/LO Pad

Touch this pad to select the broil function.

BROIL Light

Flashes while in edit mode—you can switch from HI to LO BROIL at this point. Glows when the oven is in broil mode.

Instructions Operating

+ Pad

Short taps to this pad will increase the time or temperature by small amounts. Touch and hold the pad to increase the time or temperature by larger amounts.

SELF CLEAN Pad

Touch this pad to select the self-cleaning function. See the Using the self-cleaning oven section.

CLEAN Light

Flashes while in edit mode—you can change the length of time for the self-clean cycle at this point. Glows when the oven is in the self- clean cycle. After the self-clean cycle, the light will turn off. Unlatch the door.

Indicator Lights (on some pads)

EDIT mode lasts several seconds after the last pad press. DELAY START ON/OFF and COOKING TIME ON/OFF will be the only pads lit if either of these options is selected. (Example: DELAY START is selected with BAKE—theDELAY START pad will remain lit until the clock reaches the programmed time, at which point it will turn off and the BAKE/TEMP RECALL pad light will light up).

Instructions Care and Cleaning

CONTROL LOCK/UNLOCK

PRESS + AND – AND HOLD FOR 3 SECONDS

Control Lockout

Your control will allow you to lock out the touch pads so they cannot be activated when touched.

To lock/unlock the controls:

Touch the + and – pads at the same time for 3 seconds, until the display shows LOC ON.

To unlock the control, touch the + and – pads at the same time for 3 seconds, until the display shows

LOC OFF.

When this feature is on and the touch pads are touched, the control will beep and the display will show LOC ON.

■The control lockout mode affects all touch pads. No touch pads will work when this feature is activated.

■The adjustment will be retained in memory after a power failure.

Troubleshooting Tips Consumer

Power Outage

If a flashing time is in the display, you have	To reset the clock, touch the CLOCK pad.
experienced a power failure. Reset the clock.	Enter the correct time of day by touching
	the + or – pads. Touch the START/ON pad.
	7

Support