GE JGBS20 Instructions Operating, Broiler Pan and Grid, Removable Broiler Drawer on some models

Page 21
Broiler Pan and Grid

www.GEAppliances.com

Safety

Grid

Pan

Broiler Pan and Grid

After broiling, remove the broiler pan from the oven. Remove the grid from the pan. Carefully pour out grease from the pan into a proper container. Wash and rinse the broiler pan and grid in hot water with a soap-filled or plastic scouring pad.

If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth. Soaking the pan will remove burned-on foods.

The broiler pan and grid may be cleaned with a commercial oven cleaner.

Both the broiler pan and grid can also be cleaned in a dishwasher.

Do not store a soiled broiler pan and grid anywhere in the range.

Instructions OperatingCAUTION: Do not clean the broiler pan or grid in a self-cleaning oven.

Instructions Operating

Removable Broiler Drawer (on some models)

To remove:

When the broiler is cool, remove the grid and pan.

Pull the broiler drawer out until it stops, then push it back in about one inch.

Grasp the handle, lift and pull the broiler drawer out. Clean the broiler drawer with hot soapy water.

To replace:

Hold the broiler drawer in the raised position as you slide it partway into the range. Then lower the drawer and push it completely closed.

Oven Air Vents

Never block the vents (air openings) of the

Air openings are located at the rear of

range. They provide the air inlet and outlet

the cooktop, at the top and bottom of the

that are necessary for the range to operate

oven door, and at the bottom of the range,

properly with correct combustion.

under the kick panel or broiler drawer

Vent appearance and location vary.

(depending on the model).

Lower Control Panel (Front Manifold Panel) and Knobs

Pull the knob straight off the stem.

It’s a good idea to wipe the control panel after each use of the oven. Use a damp cloth to clean or rinse. For cleaning, use mild soap and water or a 50/50 solution of vinegar and water. For rinsing, use clean water. Polish dry with a soft cloth.

Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel— they will damage the finish.

Do not bend knobs by pulling them up or down or by hanging a towel or other such loads. This can damage the gas valve shaft.

The control knobs may be removed for easier cleaning. To remove a knob, pull it straight off the stem. If knob is difficult to remove, place a towel or dishcloth between the knob and control panel and pull gently. Wash the knobs in soap and water or a vinegar and hot water solution.

Metal parts can be cleaned with soap and water. Do not use steel wool, abrasives, ammonia, acids or commercial oven cleaners. Dry with a soft cloth.

Instructions Installation Instructions Troubleshooting Tips Consumer Support

21

Image 21
Contents Non-Self-Cleaning Gas 183D5580P155 49-85068 12-03 JRSafety Instructions . . . .2-7 Operating Instructions Care and CleaningSafety Instructions IMPORTANT SAFETY INFORMATION READ ALL INSTRUCTIONS BEFORE USINGTips Installation Instructions Operating Instructions Consumer Support TroubleshootingSAFETY PRECAUTIONS IMPORTANT SAFETY NOTICESafety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer SupportOperating Instructions Safety IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USINGConsumer Support Troubleshooting Tips Installation Instructions InstructionsCOOK MEAT AND POULTRY THOROUGHLY… OVENSafety Instructions Operating SURFACE BURNERS Installation Instructions Troubleshooting Tips Consumer Support SafetySURFACE BURNERS cont SAVE THESE INSTRUCTIONSSupport Troubleshooting Using the gas surface burnersTips Installation Instructions Operating InstructionsOperating Instructions Installation Safety InstructionsHow to Select Flame Size Consumer SupportTips Installation Using the clock and timerInstructions Operating Instructions Safety Instructions To Set the Kitchen TimerInstructions Installation Using the ovenInstructions Troubleshooting Instructions OperatingHow to Set the Oven for Baking or Roasting Instructions SafetyPreheating and Pan Placement Instructions OperatingInstructions Operating Instructions Installation Instructions SafetyHow to Set the Oven for Broiling Tips Consumer SupportSecond Side Broiling GuideBacon Ground BeefSafety Instructions Adjust the oven thermostat-Do it yourselfInstructions Troubleshooting Tips Consumer Support To Adjust the ThermostatTips Installation Instructions Operating Instructions Care and cleaning of the rangeConsumer Support Troubleshooting Standard Twin Burner Assemblies on some modelsBurner Grates Instructions Operating InstructionsSafety NOTE Do not use steel wool or scouring powders to clean the burnersReplacement After cleaningBurner caps Burner headsTo Order Cooktop SurfaceInstallation Instructions Troubleshooting Instructions Operating InstructionsInstallation Instructions Operating Instructions Safety Instructions Consumer Support Troubleshooting TipsLift-Off Oven Door Oven BottomBroiler Pan and Grid Instructions OperatingRemovable Broiler Drawer on some models Oven Air VentsCautions about using spray-on oven cleaners Oven ShelvesTo Clean the Continuous-Cleaning Oven Special Care of Continuous-Cleaning Oven Interior on some modelsBEFORE YOU BEGIN IN THE COMMONWEALTH OF MASSACHUSETTSInstallation Instructions RangeFOR YOUR SAFETY Installation InstructionsTOOLS YOU WILL NEED PART INCLUDEDINSTALLATION SAFETY INSTRUCTIONS 24 INCHESMUST NEVER BE LESS THAN 24 INCHES The range may be placed with 0″ clearance flush at the back wall DIMENSIONS AND CLEARANCES36 ″ 1/4 ″LOCATION ANTI-TIP DEVICEMODEL AND SERIAL NUMBER LOCATION Take the accessory pack out of the oven and/or drawer2 CONNECT THE RANGE TO GAS 1 PROVIDE ADEQUATE GAS SUPPLYWARNING - DO NOT USE A FLAME TO CHECK FOR GAS LEAKS Installation Instructions RIGID PIPE HOOKUP OPTIONS for models equipped with Sealed Burners FLEXIBLE CONNECTOR HOOKUP for models equipped with Sealed BurnersAlternate Hookup Gas Flow into RangeFLEXIBLE CONNECTOR HOOKUP for models equipped with Standard Twin BurnersRIGID PIPE HOOKUP for models equipped with Standard Twin Burners FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED 3 ELECTRICAL CONNECTIONSElectrical Requirements Extension Cord Cautions4 SEAL THE OPENINGS 3 ELECTRICAL CONNECTIONS cont5 LIGHT THE PILOTS Electric DisconnectB Adjust the Surface Burner Pilots if Necessary 5 LIGHT THE PILOTS contC Light the Oven Pilot C Light the Oven Pilot contTo Remove the Broiler Drawer D Check Ignition of Oven BurnerStanding Pilot Models F Check Ignition of Surface BurnersElectric Ignition Models Quality of Flames7 INSTALL THE ANTI-TIP DEVICE 6 LEVEL THE RANGE2 1⁄ 8 ″ 7 INSTALL THE ANTI-TIP DEVICE cont WHEN ALL HOOKUPS ARE COMPLETEDCONVERT TO LP GAS or convert back to natural gas from LP Problem Before you call for service…See the Care and cleaning of the range section Installation InstructionsSee the Care and cleaning of the range section See the Using the clock and timer sectionSee the Installation of the range section See the Light the Oven Pilot section in the Installation“Crackling” or Power outage“popping” sound Rainbow effect inWarranty Registration Department P.O. Box Louisville, KY GE Service Protection PlusGeneral Electric Company We’ll Cover Any Appliance. Anywhere. AnytimeModel Number Follow these three steps to protect your new appliance investmentSerial Number Consumer Product Ownership RegistrationLooking For Something More? AccessoriesGE’s innovative, self-cleanable porcelain-coated oven racks Heavy Duty Durable Able to be cleaned in a self-cleaning ovenConsumer Support Troubleshooting Tips Installation Instructions Instructions Safety InstructionsGE Gas Range Warranty. For customers in the United States OperatingInstructions Installation Instructions Troubleshooting Tips Consumer SupportSafety Instructions Operating GE Gas Range Warranty. For customers in CanadaParts and Accessories Schedule ServiceConsumer Support GE Appliances Website