GE JDS28CKCC Hot or too cold, Oven will not work, Crackling or, Popping sound, A number, Display

		ge.com
Problem	Possible Causes	What To Do
Oven temperature too	Oven thermostat	• See the Adjust the oven thermostat—Do it yourself!
hot or too cold	needs adjustment.	section.
Oven will not work	Plug on range is not	• Make sure electrical plug is plugged into a live,
	completely inserted in	properly grounded outlet.
	the electrical outlet.
	A fuse in your home may	• Replace the fuse or reset the circuit breaker.
	be blown or the circuit
	breaker tripped.
	Oven controls improperly set.	• See the Using the oven section.
“Crackling” or	This is the sound of the	• This is normal.
“popping” sound	metal heating and cooling
	during the cooking functions.
“F – and a number	You have a function	• Press the CLEAR/OFF pad. Put the oven back into
or letter” flash	error code.	operation.
in the display
	If the function code repeats.	• Disconnect all power to the range for at least 30
		seconds and then reconnect power. If the function
		error code repeats, call for service.
Display flashes “bAd”	The installed connection	• Contact installer or electrician to correct miswire.
then “linE” with a	from the house to the unit
loud tone	is miswired.
Display goes blank	A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
	blown or the circuit
	breaker tripped.
	The clock is turned off from	• See the Using the clock and timer section.
	showing in the display.
Display flashes	Power failure.	• Reset the clock.
Unable to get the	Oven control pads were	• The BAKE and BROIL HI/LO pads must be pressed
display to show “SF”	not pressed properly.	at the same time and held for 3 seconds.
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by pressing the CLEAR/OFF pad, setting the clock
		and resetting any cooking function.

19

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support