MAINTENANCE
WARNING
Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
LIGHT BULB REPLACEMENT
Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set which generate the flames and embers.
TOOL REQUIREMENTS
Slot screw driver
HELPFUL HINTS
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs.
UPPER LIGHT BULB REQUIREMENTS
Quantity of 1
UPPER BULB REPLACEMENT
1.Open door by pulling the handle.
2.Locate the upper bulb bracket.
3.Bend light retainer bracket down.
4.Locate and remove the light bulb.
5.Insert new bulb.
6.Bend light retainer bracket back into its original position.
7.Close the door.
LOWER LIGHT BULB REQUIREMENTS
Quantity of 3 – 35 watt Halogen Quartz lamps, 120 volt, G9 base. DO NOT EXCEED 35
WATTS PER BULB
LOWER BULB REPLACEMENT
1.Remove the stove pipe kit (if equipped).
2.Gently place stove on its back on a flat surface.
3.Remove the heater cover retaining screws located on the bottom of the stove and lower heater and light assembly out onto the floor.
4.Remove the burnt out bulb(s) by pulling straight out of socket. If bulbs are difficult to remove form socket move the bulb from side to side while pulling being careful not to damage the light socket.
5.Replace the lower light bulbs.
6.Reassemble in the reverse order as above.
5