Aga Ranges F107411-01 manual To Change Cooktop or Broiler Controller

Page 19

SERVICING  WARNING

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

13.To Change Cooktop or Broiler Controller

Lift up the ceramic hob top (see 4). Remove control panel (see 8). Disconnect wiring from controller – make a note of the wire colors and terminal connections. Refer to the wiring schematic.

Remove 2 screws holding controller to mounting panel. Fit new controller and reassemble in reverse order. Check that the wiring is correct as shown in the wiring schematic.

Check for correct operation.

14.To Remove Broiler Outer Door Panel

Open left hand oven door and remove 2 screws from bottom edge of broiler door. Open broiler door, support broiler door outer panel and remove two screws from top inner face of broiler door. There is a pad of fibre insulation inside the door.

Reassemble in reverse order making sure that the pad of insulation is in place.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents F107411-01 Electric Range Service InstructionsALL Ranges can TIP Servicing  Warning SectionsServicing  Warning Diagnostics Action Result Possible CauseChecking the Multifunction Oven Element Checking the Convection Oven Page Servicing Procedures Lower the front roller Remove the drawerTo refit the draw Replaceing the RangeTo Lift up the Ceramic Hob To replace a hob element To replace the cooktop neon indicator lights pack To Remove Oven Light Switch Left Hand Multifunction oven Right Hand ovenTo Change Cooktop or Broiler Controller To Remove an Oven Door To Adjust the Oven Door Angle To Change Oven Door Outer Panel Re-tighten the locknut Remove the oven inner back as detailed in Section Top Element Bottom ElementServicing  Warning Broiler Technical DataElectric 240V 60Hz OvensCode Color Schematic diagram of the RangeSchematic diagram of the Range Page
Top Page Image Contents