KitchenAid KCCC151, KUCC151 manual Adjusting the Toe Plate, Custom-made panel dimensions

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:

1.Mark on each side of the toe plate the amount of toe plate that rubs the floor covering.

2.Remove the drawer from the unit. (See step 3 in the “Unpacking Your Compactor” section.)

3.Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate.

4.Use scissors or utility knife to cut toe plate along line.

7⁄32"	145⁄8"
(5.6 mm)	(37.2 cm)

raised panel or decorative trim

outer section of panel

5⁄16"

(8 mm) both sides

11⁄4"

(32 mm)

2313⁄16"

(60.5 cm)

5⁄16"

(8 mm)

5.Replace drawer. If toe plate still rubs floor covering, repeat steps 1-4.

Changing the

Decorative Panel

Custom-made panel dimensions

Raised panel: The outer section of panel must be 7⁄32"

(5.6 mm) thick to fit into trim. Raised panel dimensions as shown above.

Trim for decorative panel

Order trim for installation of a custom-made panel through your KitchenAid dealer or by calling the KitchenAid Consumer Assistance Center at 1-800-422-1230. In Canada, call 1-800-807-6777.

Trim for custom-made panels available are:

Part No. 9871381 (Brushed stainless steel)

Part No. 9871382 (White)

Part No. 9871383 (Black)

Part No. 9871384 (Almond)

Part No. 9871600 (Biscuit)

2313⁄16"

(60.5 cm)

145⁄8" (37.2 cm)

Flat panel: A 7⁄32" (5.6 mm) thick panel is required. This is the same thickness as a standard 1⁄4" plywood or paneling.

9