3.Press inside of bag against the drawer bottom, sides and corners for a smooth fit.
COMPACTOR CARE
Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do in order to properly maintain your compactor. This section will tell you how to clean and care for your compactor.
Changing the AirFilter orFreshener
It is recommended that you use either the charcoal air filter or the air freshener in the filter compartment. The solid air freshener system is an alternative to the air filter and is designed to control odors that might develop in the trash.
To order the correct replacement charcoal filters or air fresheners, call the
1.Insert fingertips in the air filter cover and pull until the side tabs release. Then, lift the cover to release the bottom tabs.
2.Remove the air filter by pulling the top edge of the filter. The filter should pull out easily. Throw away used filter.
OR
Remove the air freshener by simply lifting out of the filter compartment. Throw away used freshener..
3.To replace air filter, push the replacement filter into place.
OR
To replace the air freshener, place the replacement in the filter compartment.
4.Insert the bottom tabs of the air filter cover and push in until the side tabs snap into place.
Cleaning
Before cleaning the compactor, turn the
NOTE: Any services other than those outlined in this section should be performed by a designated service representative.
Cleaning Exterior Surfaces
1.Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Rinse and dry thoroughly with a soft cloth.
2.Wipe up spills right away. Some foods can damage the finish if left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear protective gloves since there may be bits of glass in the drawer.
1.Remove the bag. See the “Removing a Filled Bag.”
2.Press down on the
3.Hold the
NOTE: If desired, the drawer side can be removed by tilting it up, then lifting it out.
4.Wash the interior of the drawer with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth.
5.If the drawer side was removed, slide it back into the tilted position.
6.Press the
7.Latch the drawer side by pushing up the
Cleaning Inside the Cabinet
NOTE: You may want to wear protective gloves since there may be bits of glass in the cabinet.
1.Pull the drawer out until it stops.
NOTE: Look to see how the drawer rollers move in the tracks. It will be easier to replace the drawer after you have finished cleaning.
2.Lift the front of the drawer to clear the stops.
9