Multiquip MVH306GH manual Basic Engine, Honda GX270 Engine Components

Page 15

BASIC ENGINE

Figure 5. Honda GX270 Engine Components

INITIAL SERVICING

The engine (Figure 5) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions & details of operation and servicing. The engine shown above is a HONDA engine, operation for other types of engines may vary somewhat.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

WARNING

Add fuel to the tank only when the engine is stopped and has cooled down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3. Engine ON/OFF Switch – ON position permits engine

 

starting, OFF position stops engine operations.

4.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

5.

Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

 

the flow of fuel.

6.

Choke Lever – Used in the starting of a cold engine, or in

 

cold weather conditions. The choke enriches the fuel

 

mixture.

7.

Air Cleaner – Prevents dirt and other debris from entering

 

the fuel system. Remove wing-nut on top of air filter

 

cannister to gain access to filter element.

NOTICE

Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

8. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.

9. Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat.To prevent burns, DONOTtouch these areas while the engine is running or immediatelyafteroperating.NEVERoperate the engine with the muffler removed.

10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.

MVH306GH PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #8 (01/31/14) — PAGE 15

Image 15
Contents Model MVH306GH Proposition 65 Warning Page Mikasa MVH306GH Reversible Plate Compactor Table of ContentsOrdering parts has never been easier Parts Ordering ProceduresSafety Messages Safety InformationGeneral Safety Compactor Safety Fuel Safety Transporting Safety MVH-306GH Reversible Plate Compactor Specifications SpecificationsMVH306GH Reversible Plate Compactor Dimensions DimensionsGeneral Information MVH306GH Reversible Plate Compactor Components ComponentsHonda GX270 Engine Components Basic EngineChecking the Hydraulic Oil Level InspectionBefore Starting Checking Engine Oil LevelChecking The Fuel Oil Tank Front View Checking the Air CleanerOperation Releasing the HandleStarting the Engine Honda engine Traveling Normal Shutdown Travel LeverMaintenance Inspection and Maintenance Service TablesDaily Service Air Filter Spark Plug Replacing Clutch  Reinstalling the V-beltChecking and Replacing the V-Belt and Clutch  Checking ClutchAdding Hydraulic Oil TroubleshootingEngine Troubleshooting TroubleshootingAir cleaner not clean? Troubleshooting Compactor Xxxxx only Not Used on Explanation of Code in Remarks ColumnMVH-306WITH Honda GX270K1SMX2 Engine Suggested Spare PartsNameplate and Decals Nameplate and DecalsDecal MQ Logo Decal Model LogoVibrating Plate Assy Vibrating Plate AssyPacking 1/4 CU Vibrating PlateDrain Plug MI8 H Copper PackingBase and Engine Assy Base and Engine AssyBolt 8X25 T Base & Engine AssyBase Belt CoverBase and Engine Assy Gasketoil Drain Union TIP, DrainDrain Hose Hose BandVibrator Assy Vibrator AssyGEAR, Drive Vibrating CaseRoller Bearing NJ310EMC4 Rotary SHAFT, DriveControl Handle Assy Control Handle AssyRubber Coupling Handle BracketHandle Bracket R WASHER, Flat M12Control Handle Assy Handle Boss Throttle WireCOLUMN, Handle Travel LeverHand Pump Assy Hand Pump AssyAccumlator Includes Items W/# AIR Cleaner Assy GX270K1SMX2 AIR Cleaner AssyCOLLARB,AIR Cleaner COVER, AIR CleanerGROMET,AIR Cleaner COLLAR,AIR CleanerCamshaft Assy GX270K1SMX2 Camshaft AssyARM,VALVE Rocker SPRING,WEIGHT ReturnNUT,PIBOT Adjusting ROD,PUSHCarburetor Assy GX270K1SMX2 Carburetor AssyFloat SET PLATE,LEVER SettingGasket SET Valve SET,FLOATControl Assy GX270K1SMX2 Control AssyROD, Governor Adjusting SpringHOLDER, Wire ARM, GovernorCrankcase Cover Assy GX270K1SMX2 Crankcase Cover AssyPACKING, OIL Filler CAP PACKINNG,CASE CoverCrankshaft Assy GX270K1SMX2 Crankshaft AssyBolt WASHER,LOCK 8MMBEARING, Ball 6206 SH Cylinder Barrel Assy GX270K1SMX2 Cylinder Barrel AssyRing 14MM Switch ASSY,OIL LevelSHAFT,GOVERNOR ARM BOLT,DRAIN PlugCylinder Head Assy GX270K1SMX2 Cylinder Head AssyCover COMP.,HEAD GUIDE,IN.VALVEOVERSIZECLIP,VALVE Guide GASKET, Cylinder HeadFAN Cover Assy GX270K1SMX2 FAN Cover AssyCLIP, Harness Stop Switch AssyCLIP,TUBE ShroudFlywheel Assy GX270K1SMX2 Flywheel AssyNUT,SPECIAL 16MM FAN, CoolingPULLEY, Starter Flywheel CompFuel Tank Assy GX270K1SMX2 Fuel Tank AssyFuel Filter RUBBER,SUPPORT107MMJOINT,FUEL Tank Tank COMP., Fuel NH1Ignition Coil Assy GX270K1SMX2 Ignition Coil AssyCoil AY,IGNITION/GX390 CAP AssyGROMMET,CORD Muffler Assy GX270K1SMX2 Muffler AssyGasket Muffler CompPROTECTOR, Exhaust Pipe PIPE,EXHAUSTPiston Assy GX270K1SMX2 Piston AssyPIN ,PISTON BOLT, Connecting RODRing SET, Piston STD Piston STDRecoil Starter Assy GX270K1SMX2 Recoil Starter AssySPRING,STARTER Return PULLEY,RECOIL StarterRATCHET,STARTER SPRING,FRICTIONLabels Assy GX270K1SMX2 Labels AssyLabel EmblemRabel /GX120K1 MARK,CHOKEORANGEFreight Policy Terms and Condition of Sale PartsPage HERE’S HOW to GET Help

MVH306GH specifications

The Multiquip MVH306GH is a versatile, heavy-duty vibratory plate compactor designed for a variety of soil and asphalt compaction applications in construction and landscaping. This powerful machine is built to deliver optimal performance while ensuring operator comfort and ease of use.

One of the main features of the MVH306GH is its robust Honda GX160 engine, which provides reliable power and high efficiency. The engine generates sufficient force to achieve deep compaction in different soil types, including clay, sand, and gravel. With its ability to produce 3,600 vibrations per minute, the MVH306GH ensures that the compaction is uniform, reducing the likelihood of future settlement in the compacted material.

Another noteworthy feature of the MVH306GH is its durable construction. The compactor is constructed with a heavy-duty steel plate that can withstand the rigors of daily use on construction sites. Its high-quality build guarantees longevity and reduces the need for frequent maintenance. The unit is also equipped with a foldable handle, which enhances its portability and storage, especially in tight spaces.

Comfort and usability are paramount in the design of the MVH306GH. The machine features an ergonomic vibration-dampened handle that minimizes operator fatigue during prolonged use. This design consideration allows operators to work efficiently without experiencing discomfort, leading to increased productivity on the job site.

The MVH306GH is also equipped with a reliable water tank, allowing for the added benefit of wet compaction, which is essential when working on asphalt. The ability to use water helps to bond materials together, resulting in a more stable and durable surface.

In terms of technology, the MVH306GH features an advanced vibration system that optimizes the compactor's performance. This system helps in achieving maximum compaction density while minimizing the likelihood of over-compaction that can lead to future cracking or damage.

Overall, the Multiquip MVH306GH vibratory plate compactor is an ideal choice for contractors looking for a powerful, efficient, and user-friendly solution for their compaction needs. With its impressive features, durable construction, and thoughtful design, this machine proves to be a valuable asset in any construction or landscaping project.