Sharp R-1480, R-1482 Blown Monitor Fuse Test, Hood Thermal CUT-OUT Test, Hood FAN Motor Test

Sharp R-1480, R-1482, R-1481 service manual Product Specification, General Information, Description, Grounding Instructions Sharp R-1482, R-1480, R-1481 service manual Oven Diagram Sharp R-1481, R-1480, R-1482 service manual Operation, Description of Operating Sequence, OFF Condition, Cooking Condition Sharp R-1480, R-1482, R-1481 service manual Power Level P-0 to P-90 Cooking, Compu Cook, Compu Defrost Cooking Sharp R-1482, R-1480, R-1481 Ventilation Methods HOT AIR Exhaust, Vertical Venting, AIR Flow, Horizontal Venting Sharp R-1481, R-1480, R-1482 service manual Figure O-1. Oven Schematic-Off Condition Sharp R-1480, R-1482, R-1481 service manual Description and Function of Components Sharp R-1482, R-1480, R-1481 service manual Troubleshooting Guide, Stirrer Motor, Hood Lamp Sharp R-1481, R-1480, R-1482 service manual Possible Case Defective Parts Sharp R-1480, R-1482 Test Procedures, Procedure Letter Component Test Magnetron Assembly Test, Microwave Output Power Sharp R-1482, R-1480, R-1481 Procedure Letter Component Test, High Voltage Rectifier Test, High Voltage Capacitor Test Sharp R-1481 Secondary Interlock Switch Test, Primary Interlock System Test Door Sensing Switch, Monitor Switch Test Sharp R-1480, R-1482, R-1481 service manual Blown Monitor Fuse Test, Hood Thermal CUT-OUT Test, Hood FAN Motor Test Sharp R-1482, R-1480, R-1481 service manual WHT 3, Touch Control Panel Assembly Test, Before testing Sharp R-1481, R-1480, R-1482 service manual KEY Unit Test Sharp R-1480 Procedure Letter Component Test Relay Test, Compu Defrost Test, Foil Pattern on the Printed Wiring Board Test Sharp R-1482, R-1480, R-1481 service manual Procedure Component Test Letter, Steps Occurrence Cause or Correction Sharp R-1481, R-1480, R-1482 service manual Touch Control Panel Assembly Sharp R-1480, R-1482, R-1481 service manual Description of LSI, LSIIZA876DR Sharp R-1482, R-1480 Signal to sound buzzer, Auto clear terminal, Signal coming from touch key, Signal similar to P27 Sharp R-1481, R-1480, R-1482 service manual Segment data signals, Key strobe signal Sharp R-1480 Shapes of Electronic Components, Servicing of Touch Control Panel, Servicing Tools, Other Precautions Sharp R-1482, R-1480, R-1481 service manual Component Replacement and Adjustment Procedure, Hood Exhaust Louver Removal Sharp R-1481, R-1480 Outer Case Removal, Power Transformer Removal, Hood FAN MOTOR, Hood Duct and Oven Lamp Socket Removal Sharp R-1480 Magnetron Removal, High Voltage Rectifier and High Voltage Capacitor Removal, Thermal CUT-OUT Cavity Removal Sharp R-1482, R-1480, R-1481 service manual Temperature Fuse Magnetron Removal, Cooling FAN Motor Removal, Rear View Sharp R-1481 Turntable Motor Removal, Stirrer Motor Removal, Stirrer Cover and Stirrer FAN Installation, Oven Lamp Removal Sharp R-1480, R-1482, R-1481 service manual Positive Lock Connector NO-CASE Type Removal, Step, Positive lock connector Sharp R-1482, R-1480, R-1481 Door Replacement, Control Unit and KEY Unit Removal, After adjustment, check the following Sharp R-1481 Door Disassembly, After any servicing, make sure of the following, Choke Cover, Door Frame, Door Glass Sharp R-1480, R-1482, R-1481 service manual Figure S-1. Pictorial Diagram Sharp R-1482, R-1480, R-1481 service manual Circuit Sharp R-1481, R-1480, R-1482 service manual Dip, Bfb Sharp R-1480 Parts List, Parts marked * are used in voltage more than, Electric Parts, Cabinet Parts, Control Panel Parts Sharp R-1482, R-1480, R-1481 service manual Oven Parts, Door Parts Sharp R-1481, R-1480 HOW to Order Replacement Parts, Miscellaneous, SCREWS,NUTS and Washers, Model Number, Description
Page 18

R-1480

R-1481

R-1482

TEST PROCEDURES

PROCEDURE

LETTER

COMPONENT TEST

with the door opened (in this condition the plunger of the monitor switch is pushed in), the meter should indicate an open circuit. If improper operation is indicated, the switch may be defective. After testing the monitor switch, reconnect the wire lead to the monitor switch (COM) terminal and check the continuity of the monitor circuit.

5.Reconnect all leads removed from components during testing.

6.Reinstall the outer case (cabinet).

7.

Reconnect the power supply cord after

Black

White/White

 

the outer case is installed.

 

 

8.

Run the oven and check all functions.

 

 

Screw Driver

 

Secondary

Monitor

Interlock

Switch

Switch

Ohmmeter

IBLOWN MONITOR FUSE TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.If the monitor fuse is blown when the door is opened, check the primary interlock relay, secondary interlock switch and monitor switch according to the "TEST PROCEDURE" for those switches before replacing the blown monitor fuse.

CAUTION: BEFORE REPLACING A BLOWN MONITOR FUSE, TEST THE PRIMARY INTERLOCK RELAY, SECONDARY INTERLOCK SWITCH, DOOR SENSING SWITCH AND MONITOR SWITCH FOR PROPER OPERATION.

If the monitor fuse is blown by improper switch operation, the monitor fuse and monitor switch must be replaced with "monitor fuse and monitor switch assembly" part number FFS-BA016/KiT, even if the monitor switch operates normally. The monitor fuse and monitor switch assembly is comprised of a 20 ampere fuse and switch.

5.Reconnect all leads removed from components during testing.

6.Re-install the outer case (cabinet).

7.Reconnect the power supply cord after the outer case is installed.

8.Run the oven and check all functions.

JHOOD THERMAL CUT-OUT TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.A continuity check across the thermal cut-out terminals should indicate an open circuit unless the temperature of the thermal cut-out reaches approximately 140˚F(60˚C) or more. At that temperature, the contacts will close. The thermal cut-out opens automatically at approximately 113˚F(45˚C).

5.Reconnect all leads removed from components during testing.

6.Reinstall the outer case (cabinet).

7.Reconnect the power supply cord after the outer case is installed.

8.Run the oven and check all functions.

KHOOD FAN MOTOR TEST

1.Disconnect the power supply cord, and then remove outer case.

2.Open the door and block it open.

3.Discharge high voltage capacitor.

4.If the motor does not turn, touch the FAN HI / LO pad once (set hood fan motor power "HIGH") and check voltage between pins "1" and "2" (Blue and Black wires) of the 6 pin connector. If 120 Volts appear and the hood capacitor is good, replace the hood fan assembly. If 120 Volts does not appear, check the motor circuit. The resistance values of motor terminals are as follows:

16

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Table of Contents Over the Range Microwave OvenBefore Servicing When the testing is completed Dont Touch Before ServicingMicrowave Measurement Procedure RequirementsLeakage test 1480 / R-1481 / R-1482 Sharp PLAZA, MahwahOver the Range Microwave Oven ForewordDescription Product SpecificationGeneral Information Grounding InstructionsOven Diagram OFF Condition OperationDescription of Operating Sequence Cooking ConditionPower Level P-0 to P-90 Cooking Compu CookCompu Defrost Cooking AIR Flow Ventilation Methods HOT AIR ExhaustVertical Venting Horizontal VentingFigure O-1. Oven Schematic-Off Condition Description and Function of Components Troubleshooting Guide Stirrer MotorHood Lamp Possible Case Defective Parts Microwave Output Power Test ProceduresProcedure Letter Component Test Magnetron Assembly Test Power Transformer TestHigh Voltage Rectifier Test Procedure Letter Component TestMagnetron Temperature Fuse Test High Voltage Capacitor TestMonitor Switch Test Secondary Interlock Switch TestPrimary Interlock System Test Door Sensing Switch Primary Interlock Relay RY2Blown Monitor Fuse Test Hood Thermal CUT-OUT TestHood FAN Motor Test Touch Control Panel Assembly Test Before testingWHT 3 KEY Unit Test Foil Pattern on the Printed Wiring Board Test Procedure Letter Component Test Relay TestWeight 1ST Stage 2ND Stage 3RD Stage 4TH Stage Level Time Compu Defrost TestProcedure Component Test Letter Occurrence Cause or CorrectionSteps Occurrence Cause or Correction Touch Control Panel Assembly Description of LSI LSIIZA876DRSignal similar to P27 Signal to sound buzzerSignal coming from touch key Digit selection signalSegment data signals Segment data signalKey strobe signal Shapes of Electronic Components Other PrecautionsServicing Servicing of Touch Control PanelComponent Replacement and Adjustment Procedure Hood Exhaust Louver RemovalOuter Case Removal Power Transformer RemovalRe-install Hood FAN MOTOR, Hood Duct and Oven Lamp Socket RemovalHood FAN Thermal CUT-OUT Removal Magnetron RemovalHigh Voltage Rectifier and High Voltage Capacitor Removal Thermal CUT-OUT Cavity RemovalTemperature Fuse Magnetron Removal Cooling FAN Motor RemovalRear View Turntable Motor Removal Stirrer Cover and Stirrer FAN InstallationControl Panel ASSEMBLY, Control Unit and KEY Unit Removal Stirrer Motor RemovalPositive Lock Connector NO-CASE Type Removal Positive lock connectorStep Door Assembly Removal Door ReplacementAfter adjustment, check the following Door Assembly RE-INSTALLChoke Cover Door DisassemblyAfter any servicing, make sure of the following Door FrameFigure S-1. Pictorial Diagram Circuit DIP BFBElectric Parts Parts ListParts marked * are used in voltage more than Cabinet PartsOven Parts Door PartsSCREWS,NUTS and Washers HOW to Order Replacement PartsMiscellaneous Model NumberOven and Cabinet Parts Control Panel Parts Door Parts Miscellaneous Packing and Accessories Copyright 1998 by Sharp Corporation ALL Rights Reserved

R-1481, R-1482, R-1480 specifications

Sharp R-1480, R-1481, and R-1482 are popular countertop microwave ovens that exemplify innovation in home cooking technology. These models are designed to cater to modern culinary needs, combining functionality, efficiency, and user-friendly features.

The Sharp R-1480 stands out with its powerful 900 watts of cooking power, ensuring that meals are cooked evenly and thoroughly. This model includes a spacious 1.5 cubic feet capacity, allowing users to cook larger dishes without hassle. One of the most striking features of the R-1480 is its advanced Sensor Cooking technology. This intelligent feature automatically adjusts cooking time and power levels based on the type of food being prepared, delivering optimal results with minimal effort.

The R-1481 model shares many similarities with the R-1480 but introduces additional features that enhance convenience and usability. It also boasts a 900-watt power output and a 1.5 cubic feet interior. What sets the R-1481 apart is its impressive variety of pre-programmed settings. These settings simplify cooking tasks, giving users one-touch access to options for popular foods such as popcorn, pizza, and frozen vegetables. The auto defrost function is another advantage, allowing for quick thawing of meats and seafood based on weight.

Meanwhile, the Sharp R-1482 takes the features of the R-1481 a step further, adding a few unique characteristics. This model incorporates both microwave and grill functionality, allowing for versatile cooking options. Users can enjoy the benefits of grilling their favorite dishes for a perfect finish and flavor infusion. The R-1482 also includes a user-friendly control panel with a large LCD display, ensuring easy navigation through the cooking process.

Across these models, Sharp emphasizes safety and ease of use. The child lock feature provides peace of mind for families, while the easy-to-clean stainless steel interior promotes hygiene and longevity. All models include a turntable for even cooking and reheating, making it easier to prepare meals uniformly.

In conclusion, the Sharp R-1480, R-1481, and R-1482 microwave ovens combine advanced technology with practical features, catering to a diverse range of cooking needs. These models stand as a testament to Sharp’s commitment to quality and innovation in the kitchen, making them excellent choices for anyone seeking efficiency and versatility in their cooking appliances.
Top Page Image Contents