K-Tec HP3A instruction manual Blended Texture Unsatisfactory

Page 14

7.3 BLENDED TEXTURE UNSATISFACTORY

If the blended texture of product is lumpy or uneven, do the following:

•Ensure the mixture is not cavitating during the cycle. Cavitation is a condi- tion in which the blender blade spins freely in an air pocket within the drink mix because the mix is too cold or too solid. This problem can be corrected by increasing the mix temperature by reducing ice, increasing liquid and/or ensuring that the frozen ingredients used in the recipe are never colder than 10 degrees Fahrenheit (-12 degrees Celsius).

•Increase cycle time. If the drink is mixing well but has not had enough time for complete blending, try a longer cycle (usually by using higher button number to start the blender) or touch and hold the “Pulse” button for required extra blending time.

•TRIED EVERYTHING? If none of the preceding suggestions work, contact your Blendtec service agent for further assistance.

INSTRUCTIONS THAT APPEAR IN THIS USER

GUIDE ARE NOT MEANT TO COVER EVERY

POSSIBLE CONDITION OR SITUATION THAT

MAY OCCUR. GOOD JUDGMENT MUST BE

USED WHEN OPERATING THIS OR ANY OTHER

MACHINERY.

HP-11

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model HP3A Page Table of Contents Avoid Contact with Moving Parts Safety CertificationCertification Never Operate the Blender if IT Appears DamagedAvoid Touching the Blender Drive Socket After Extensive USE Never Attempt to Repair the Power UnitTurn the Power Switch OFF When not in USE Recording Your Serial Number and Date of Purchase Registration of Your BlenderBlender Motor Blender JAR AssemblyInstallation HP-5 LONG-TERM Sanitation Care and Cleaning After USE CleaningCleaning Tips and Cautions Manual Controls Operational OverviewBefore YOU Begin Operation Automatic and Custom Controls Restoring Factory Defaults Blend CyclesTroubleshooting Blender Motor will not Turn on Noise Level ChangesBlended Texture Unsatisfactory Blendtec home Under Warranty OUT of WarrantyHP-14
Top Page Image Contents