Description of parts, Preparation, Starting up

Description of parts:

FIG. 01

1On-Off-switch/Power-on light

2Hot water/brew switch (pump)

3Temperature ready-light

4Steam switch (temperature)

5Drip plate

6Removable water tank

7Steam/hot water knob

8Turbo frother steam nozzle (removeable)

9Filterholder

101 cup filter (or coffee pod)

112 cup filter

12Drip tray

13“Perfect crema” device

14Brewing head

15Filterholder gasket

16Shower disc holder

17Shower disc

18Tamper

19Power cable and plug

20Measuring spoon

21Delivery spout

22Tank cover

23Removable decompression duct

24Milk frother (removeable)

Instructionsforthepowersupplycord

AA short power-supply cord is provided to reduce risks of getting tangled up or tripping over a longer cord.

BLonger extension cords are available and may be used if care is exercised in their use.

CIf a long extension cord is used:

1the marked electrical rating of the extension cord should be at least as great as the electrical rating of the appliance.

2if the appliance is of the grounded type, the extension cord should be a grounding type

3the cable does not hang from the table to avoid the risk of getting caught up in it.

ENGLISH

Preparation:

1.Remove the water tank cover (22) and fill with cold water to the MAX line indicated on tank (6). See FIG. 2.

The water tank can also be removed after disconnecting the decompression duct (23) by pulling it down and removing the drip plate (5) and the drip tray (12).

IMPORTANT: Once the tank has been reinserted, ensure that the silicon pipes are inside the actual tank and not tangled or blocked.

The decompression duct is again in the original place by pushing it up.

2.Insert plug (19) into a suitable wall outlet (see point 1 under “Caution”).

3.Turn the power switch (1) to “1”. The power- on indicator light will light up.

Make certain that the hot water/coffee switch

(2)and that the steam switch (4) are in the “0” position.

Starting up

This procedure fills the water boiler with fresh water.

This should be done whenever the machine is switched on.

This machine, featuring a pump to brew coffee, is equipped with a self-priming system. Place an empty cup under the brewing head (14), do not insert filter holder and press hot water/ coffee switch (2) (pos. “1”).

You will hear the sound of the operating pump and after few seconds, water will start to escape from the brewing head (14).

• 9 •