ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR COOKER. Inspect contents in the box to ensure all parts are included and undamaged.
FOR MISSING PARTS OR ASSISTANCE, PLEASE CALL
Proof of purchase will be required.
TOOLS REQUIRED:
Adjustable Wrench
Flathead Screwdriver
PARTS INCLUDED:
3 - Bolts 1 1/4" 4 - Bolts 3/4" 7 - Locking Nuts 3 - Bolts 3/8” 3 - Nuts 3 - Locking Washers
1- Round Frame | 3 - Legs | 1 - Burner Support Bar | 1 - BG10 Burner | 1 - Heat Shield | 1- Regulator | ||
|
|
|
| with Air Shutter |
| Hose Assembly | |
|
|
|
|
| 350 |
|
|
|
|
|
| 150 | 200 |
|
|
|
|
|
| 100 |
|
|
|
|
|
|
| 50 |
|
|
|
|
|
|
| ˚C |
|
|
|
|
|
|
| ˚C |
|
|
|
|
|
|
| ˚F |
|
|
|
1- | 1- Fry Basket | 1- Basket Handle | 1- 5" Fry Thermometer |
| |||
FRY BASKET ASSEMBLY
1.Remove fry basket and handle from the box and packing. Attach handle to the outside of basket as shown. Wrench tighten.
COOKER ASSEMBLY
1. | Remove components from the box and packing. |
| Turn base frame upside down as shown. |
| Assemble cooker while in this upside down position. |
2. | Mount Burner Support Bar - Line up holes in support |
| bar to the holes in the frame as shown. Attach bolts |
| and nuts as shown. Wrench tighten. |
3. | Attach Burner and Heat Shield to Support Bar |
| Remove locking nut from bottom of burner. Turn burner |
| upside down as shown. Position long end of burner |
5
3
Assembled Basket
2
above large "U" in the frame. Position body of burner |
below support bar as shown. Line up burner bolt to |
center hole in support bar. Insert the bolt through the |
support bar. Place heat shield over bolt. Attach locking |
nut and wrench tighten. |
4. Attach Legs to Base Frame - Slide legs on frame to |
match holes. Insert and hand tighten all bolts and nuts. |
NOTE: You will wrench tighten leg bolts at a later stage. |
5. Attach Hose to Burner - Refer to Connecting Regulator |
Hose Assembly to Cooker on page 12. |
NOTE: Do not over tighten brass hose connector |
to burner. The air control shutter must be able to easily |
turn for adjustment of flame quality. If you have over |
tightened the brass hose connector to the burner and |
the shutter cannot turn, then unscrew the brass hose |
connector until the shutter can be easily turned... |
Very Important! |
6. Return frame to upright position. Wrench tighten |
all leg bolts. |
Cooker Frame sets inside here
4
1
Manufactured Under U.S. Patent No. 6,725,856
9