START/STOP BUTTON
Once you have selected the wash program and temperature and drying options, press this button to start the dishwasher. (Make sure the door is securely closed.)
DISPLAY WINDOW
After you press Start/Stop, the display window shows the time it took the program to run last time. (The first time you run a program, a 1 will display.) As the program progresses, the time remaining displays. If the time exceeds an hour, the display alternates between the hour and minutes remaining. The hour is designated by an h, e.g., 1h).
If you select Delayed Start, the window will display the number of hours selected. It will then display the count- down time until the program starts.
The window also displays fault codes. See below.
INTERRUPTING A PROGRAM TO ADD AN ITEM
If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and place the item into the dishwasher. Close the door securely. The program will continue from where it was interrupted.
WARNING! Be extremely careful when opening the door during a program. The water is hot and you could get scalded.
CHANGING OR STOPPING A PROGRAM
If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle, you will have to add detergent.)
PROGRAM TIMES
The program times may not always be the same because of variations in the household hot water temperature. The dishwasher heats the water to the proper temperature for the program selected; so if the temperature of the water entering the dishwasher is too low, the dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times.
ACTIVATING THE CHILD-SAFE BUTTON FEATURE
As a safety measure, Model D3350 can be programmed not to start unless the Temperature and Drying buttons are held down simultaneously. To program this feature, follow the steps below:
1.Turn off the power to the machine.
2.Simultaneously press and hold down the Temperature and Drying buttons as you turn on the power to the machine. The Temperature, Drying and Start buttons will flash.
3.Release the buttons.
4.Press the Program button until the display shows 1 with a key symbol alongside it.
5.Press Start to confirm selection and return to main menu.
To deactivate the button lock, simultaneously press the Temperature and Dry buttons. You can then select the program and options and press Start to start the unit. The lock will reactivate automatically in three minutes.
To permanently deactivate the button lock, repeat these steps. When the display shows 0 and key symbol goes out, the button lock has been deactivated.
FAULT CODES
In the event that the machine should fail during a program, the display window will show a fault code. The table below defines these codes and gives possible causes and solutions. See also “Troubleshooting” on page 12.
If you have corrected the fault, turn the main power off then back on to remove the fault indication. If it still displays, try again to correct the problem or call a service technician.
Display | Type of Fault and Recommended Action |
| Too much water has entered the dishwasher. Call a service technician. |
| Water inlet fault. Make sure the water supply is open. |
| Valve leakage. Shut off the water supply and contact a service technician. |
| The drain is blocked. See “Troubleshooting” on page 12. |
| The filter is clogged. See “Cleaning the Filters” on page 9. |
Page 8