Maintaining Your Coffeemaker

Maintaining your Coffeemaker and its parts will help extend the life of the appliance.

Cleaning the Coffeemaker

Your Coffeemaker must be cleaned when you notice any of the follow conditions:

•cleaning cycle indicator light is blinking during normal brew mode (Models URTX83, URTX84 and URTX85 only)

•excessive steaming

•increased brew cycle times

•the pumping action stops before all of the water has been pumped from the water reservoir

These conditions are caused by lime or other mineral deposits.

How frequently you clean your Coffeemaker depends upon the hardness of your tap water. The following table gives suggested cleaning intervals.

TYPE OF WATER	CLEANING FREQUENCY

Soft water	Every 80 brew cycles
Hard water	Every 40 brew cycles

To clean mineral deposits from your Coffeemaker:

1)Pour four cups of dissolved MR. COFFEE® Cleaner or undiluted white household vinegar into the water reservoir.

2)Place a paper filter into the removable filter insert and close the brew basket lid.

3) Place the empty thermal carafe on the base.

Make sure to center the thermal carafe squarely on the base to avoid the possibility of overflow.

4) Start the cleaning cycle for models:

• UNT83, URT83, URT84 and URT85

a. Press the BREW NOW button.

b. As soon as the brew cycle is complete and the Coffeemaker turns off, pour dissolved MR. COFFEE® Cleaner or vinegar back into the reservoir and allow to stand for 30 minutes while the unit is “off.”

c.After 30 minutes, place the empty carafe back on the base. Turn the Coffeemaker back on to let all of the dissolved MR. COFFEE® Cleaner or vinegar flow through.

d.When the cleaning cycle is complete, discard both the dissolved MR. COFFEE® Cleaner or vinegar and the paper filter.

For Models:

• URTX83, URTX84 and URTX85

1)Press the “Clean Cycle” button.

For convenience, everything is automatic! The entire cycle will take approximately 45 minutes to complete. During the

cleaning cycle your coffeemaker will:

a. Slow brew approximately 3 cups (24 fluid ounces) of cleaner.

b. Pause for 30 minutes to allow time for the cleaning solution to dissolve mineral buildup inside the coffeemaker. During this time the clean light will stay on to alert you that the cleaning process is active.

c. After the pause, your coffeemaker

will sound three audible beeps then restart and brew the remainder of the cleaning solution.

d. When complete, the clean light will extinguish and your coffeemaker will automatically turn off.

2)Discard the cleaning solution and rinse the decanter thoroughly with clean water.

3) Fill the water reservoir with clean, fresh water.

4) Place the empty decanter on the warming plate.