SE T TING THE CLOCK AND TIMER (PRX20, PRX23, PRX28 & PRX29)
PM INDICATOR HOUR SET | MINUTE SET | BREW SET | ON/OFF |
INDICATOR
HOUR MIN BREW
7:00 |
CLOCK DISPLAY | AUTO OFF LIGHT INDICATES | CONTROL SWITCH |
ON – OFF – AUTO | ||
| AUTO BREW NEEDS TO BE RESET |
|
To Set the Clock
1.Turn the Control Switch to OFF.
2.Plug the power cord into your electrical outlet. The Clock Display will flash until you set the time.
3.Alternately press and hold the HOUR and MINUTE buttons until you reach the current time. The PM Indicator Light in the display will illuminate to indicate PM time.
To Pre-Set the Brewing Time
Press and hold the BREW button while setting the desired brew time with the HOUR and MINUTE buttons. The PM Indicator Light in the display will illuminate to indicate PM time.
NOTE: It is not necessary to set the clock in order to brew coffee. If the HOUR or MINUTE buttons are not pressed, the clock will display 12:00 and will not change. You must set the correct time in order for the clock to begin operation, or to brew at a
To Brew Automatically at the Pre-Set Time
1.Follow Steps No. 1 through No. 5 in the “Brewing Coffee” section of these instructions.
2.Turn the Control Switch to OFF and then to AUTO.
3.Brewing will begin at the time you have preset and the coffee will remain hot in the decanter for two hours. To keep your coffee hot for an additional two hours, turn the Switch
from AUTO to ON.
IMPORTANT
To Reset AUTO Brew at Pre-Set Time
The programmable timer will NOT automatically brew the next day if left in the AUTO position after its last use. This is a safety feature. If the OFF Indicator Light in the lower right hand corner of the Clock Display is illuminated, reset
AUTO BREW by turning the Control Switch to OFF and then to AUTO.
6