7.Press the ON/OFF Button to turn the Coffee Maker ON again. Allow the vinegar/water solution to cycle through the Coffee Maker. When the brew cycle is finished, press the ON/OFF Button to turn the Coffee Maker OFF and discard the vinegar/water solution.
8.To rinse: Allow the Coffee Maker to cool for 15 minutes. Fill the Carafe with cold fresh water. Pour the water into the Water Reservoir. Replace the Carafe onto the Warming Plate and press the ON/OFF Button. When the brew cycle is complete discard the water. Repeat with another Carafe of fresh water. Discard the rinse water.
9.Wash and dry all removable parts. Wipe the exterior of the Coffee Maker with a damp cloth.
|
| WARNING: Changes or modifications to this equipment |
|
| not expressly approved by the party responsible for |
|
| compliance could void the user's authority to operate |
|
| the equipment. |
|
| This device complies with Part 15 of the FCC Rules. Operation |
|
| is subject to the following two conditions: |
|
| (1) this device may not cause harmful interference, and |
|
| (2) this device must accept any interference received, including |
|
| interference that may cause undesired operation. |
|
| NOTE: This equipment has been tested and found to comply |
|
| with the limits for a Class B digital device, pursuant to Part 15 |
|
| of the FCC Rules. These limits are designed to provide |
|
| reasonable protection against harmful interference in a |
|
| residential installation. |
|
| This equipment generates, uses and can radiate radio |
|
| frequency energy and, if not installed and used in accordance |
|
| with the instructions, may cause harmful interference to radio |
User Maintenance |
| communications. However, there is no guarantee that |
| the interference by one or more of the following measures: | |
|
| interference will not occur in a particular installation. If this |
|
| equipment does cause harmful interference to radio or |
|
| television reception, which can be determined by turning the |
|
| equipment off and on, the user is encouraged to try to correct |
|
| • Reorient or relocate the receiving antenna. |
| ||
|
| • Increase the separation between the equipment and receiver. |
|
| • Connect the equipment into an outlet on a circuit different |
|
| from that to which the receiver is needed. |
|
| • Consult the dealer or an experienced radio/TV technician |
|
| for help. |
|
|
|
24
Quick Start: Plug & Play
MSN® Direct constantly streams both time and
NO
FM signal.
1. | Carefully unpack your Coffee Maker. Remove any labels from the |
|
| outside surfaces. |
|
2. | Plug the Smart Mill & Brew™ Coffee Maker into a 120V AC | Quick |
| electrical outlet. | |
|
| |
3. The “Welcome” screen will appear, followed by “Scanning for Signal.” | Start | |
| Depending on the signal strength in your area, “Acquiring Signal” | |
may remain on the LCD Display for up to 1 hour. Please be patient.
4.While the unit is scanning for the signal, you may begin to
brew a Carafe of freshly ground coffee. Simply press the
COFFEE/WEATHER Button and the “Mill & Brew Idle” screen will appear.
HELPFUL HINT: Use the 
COFFEE/WEATHER Button to toggle between Coffee Mode and Weather Mode.
5.If this is the initial use of the Coffee Maker, please consult the section entitled “Before Using Your Smart Mill & Brew™ For The First Time” and follow the steps outlined on pages 14 and 15 to make sure the unit is properly cleaned and ready for brewing.
6.After cleaning, simply add your favorite whole bean coffee and water, select the grind setting for coffee beans, then grind and brew fresh coffee immediately. Ground coffee may also be used. Please consult the “Brewing Coffee: Immediate Start” section described on pages 15 to 17 for detailed procedures.
5