MartinLogan 6 user manual Removing the Logo Badge

Page 6

2Affix the wall pads to the back of the speaker at the lower contact points (fig. 6).

3Locate mounting location using a level and the installation template.

Note: HORIZONTAL installation requires the use of TWO wall brackets.

Note: VERTICAL installation requires the use of ONE wall bracket.

4 Mark the pilot hole locations.

5Drill the pilot holes using a 1/8-inch drill bit. If a pilot hole DOES NOT hit a stud, widen that pilot hole using a 1/4-inch drill bit and install a wall anchor at that location (fig. 7).

6Using the 1-inch Phillips screws, mount the wall bracket(s) as shown (fig. 7).

7Hang the speaker, guiding the wall mount bolt into the wall bracket keyhole(s).

REMOVING THE LOGO BADGE

To remove the logo badge gently pull it away from the speaker grill (fig. 8).

Fig. 7

Fig. 8

6

Image 6

Contents E r ’ s m a n u a l E G r e a t a m e r i c a n S p e a k e r C o m p a n yDo not drive speaker beyond its rated power Serial NumberPage Connection InstallationInstalling on a Flat Surface BreakInstalling on a Wall Removing the Logo Badge Frequently Asked Questions How do I clean my speakers? Troubleshooting No OutputContacting Customer Service General Information Warranty InformationService Serial NumberSpecifications Dimensional Drawings Dimensional Drawings E G r e a t a m e r i c a n S p e a k e r C o m p a n y I d e d e l ’ u t i l i s a t e u r Avertissement Page Raccordement AVERTISSEMENT! Éteignez RodageInstallation SUR UN MUR Enlever LE Logo Dépannage Aucun signal de sortie Communiquer Avec le Service à la ClientèleFoire Aux Questions Comment nettoyer les enceintes? Renseignements Généraux Numéro DE SérieSpécifications 75 po 13,3 cm x 4,4 cmScellé Plans Dimensionnels Plans Dimensionnels