Installation Instructions for Wall and Ceiling Mounted Speakers
ESWA6550SC, ESWA6500SC, ESWA0800SC, ESWA6500SW
Installation Manual IM00412012E
New Information Effective May 2006
Wall and Ceiling Mounted Speaker Installation Instructions
Prior to Installation
Each speaker requires one speaker wire set consisting of a positive and negative wire. Eaton recommends using an 18 gauge wire or larger for the best quality sound.
Choosing the Speaker Location
Before you install your speakers you should carefully consider their location to ensure the best quality sound. Make sure to note the loca- tion of lighting fixtures, electrical wiring, plumbing, HVAC ducting, or any other possible obstructions.
Once you have selected the area for installation, locate the studs or joists nearest to the desired location. By marking the location of the stud or joist first, you can avoid cutting into it as you cut the speaker hole. A speaker cutout template is included to help you measure cut- out dimensions.
Position the template into the desired location and outline the speaker opening. If you are still not sure of possible obstructions, cut a small hole in the center of your mounting location. This small hole will allow you to check for obstructions behind the surface prior to cutting out the entire speaker hole.
If there are no problems with your mounting location, proceed to cut out the outlined hole. If the area where the speaker will be placed is not already insulated, Eaton suggests adding insulation, Dacron, or some other sound dampening material. If you add insulation with a foil layer, make sure to mount the foil side away from the speaker magnet.
Speaker cable should be run to each speaker location prior to speaker installation. In new construction applications, run the speaker wire to the speaker locations prior to drywalling.
Ceiling Placement
Speakers placed into the ceiling should be mounted above or as close to the listening area as possible. Take furniture arrangements into consideration when finalizing your speaker locations. The tweeters located in the speakers can be adjusted to point towards the listening area of the room.
Speaker Grill Removed From Frame