TROUBLESHOOTING
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the issue persists, check the troubleshooting section below. The issue could be solved by following the suggestions in the “Solution” column.
Issue | Possible Cause |
The machine won't | The icemaker is unplugged. |
operate. | The fuse is blown. |
| The icemaker power switch is |
| OFF. |
| The ice storage bin is full of ice. |
|
|
The water doesn't | The water supply tap is turn off. |
feed in after the ice | The water supply pipe is not |
maker starts. | proper connected. |
Machine makes | The condenser may be dirty. |
ice, but bin does | The air flow to the ice maker |
not fill up with ice | may be obstructed. |
| The ambient temperature and |
| water temperature are high, or it |
| is near with some heat source. |
Water is leaking | A few water droplets are on the |
out the unit. | door. |
|
|
| The water supply connection is |
| leaking. |
Cubes are partially | Not enough water in the water |
bin. | |
at the bottom. |
|
|
|
Noise during | The feet are not leveled and |
operation | locked |
| Certain sounds are normal. |
The icemaker | The electricity is off. |
stops suddenly | The room temperature is out of |
while making ice. | the stated range. |
|
|
The body of the ice | The ground line isn't in the |
maker is electrified | socket. |
Scale builds up | The calcium level in the water is |
quickly inside the | too high. |
machine. |
|
Solution
Plug the ice maker in.
Replace fuse.
Turn the ice maker power switch to ICE (ON)
Take away some ice cubes; make the ice- full probe is free of ice.
Turn on the water supply tap. Reconnect the water supply pipe.
Clean the condenser.
Check the installation.
Check the installation.
Under some conditions, humidity may condense on the door. Consider moving the unit or just be more careful when you open the door.
Tighten fitting. See “Connecting the water line”.
Check if the water supply pressure is below 0.05Mpa.
Check water
Check for a water leak at the water trough. Level and lock the feet. See Leveling the Ice Maker.
See “Normal Sounds.” Reconnect the power supply line.
Cut off the electricity and let the ice maker stop working until the temperature returns within the stated range.
Use the correct plug and outlet.
Use a
15