Heat & Glo LifeStyle TiaraE 4035-822 Getting Started, Important Instructions, Electric Service

Page 5

2Getting Started

A. Important Instructions

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

•Read all instructions before using this heater.

•This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 ft (.9m) from the front of the heater and keep them away from the sides and rear.

•Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.

•Always unplug heater when not in use.

•Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.

•Do not use outdoors.

•This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.

•Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over.

•To disconnect heater, turn controls to off, then remove plug from outlet.

•Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.

•To prevent a possible fire, do not block air intakes or exhaust in any manner.

•A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.

•Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.

•Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 16 AWG minimum size and rated not less than 1875 watts.

•Always use properly grounded fused and polarized outlets.

•Always use ground fault protection where required by electrical code.

•Always disconnect power before performing any cleaning, maintenance or relocation of the appliance.

•To prevent a possible fire, do not burn wood or other materials in this appliance.

•To prevent personal injury, do not strike appliance glass.

•To prevent electric shock or fire, always use a certified electrician should new circuits or outlets be required.

•When transporting or storing the heater, keep in a dry place free from excessive vibration and store as to avoid damage.

•SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

B. Electric Service

All wiring must be installed by a qualified elec- trician. Use appropriate wire to meet local and national codes for rated power consumption.

•The heater is wired from the factory with a polarized plug. No provisions have been made for hard wiring.

•For ease of electrical hook up, you may wish to install the heater near an existing outlet. A 15 amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit trips or fuse blows on a regular basis when the heater is operated. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.

•Before plugging the heater into the wall outlet, make sure the control switch is in the “OFF” position.

•If the cord does not reach the outlet, a No. 16-AWG minimum wire size extension cord rated for a minimum of 1875 watts may be used.

C. Inspect Stove and Components

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

•Do NOT install substitute components.

Report damaged parts to dealer.

•Carefully remove the stove and components from the packaging.

•Report to your dealer any parts damaged in shipment.

•Read all the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.

Heat & Glo • TiaraE• 4035-822 Rev F • 01/05

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Do Discn O a T R D Fireplace Unit Model Listing Label Information/LocationNumber Firebox Serial NumberTable of Contents Appliance Certification Listing and Code ApprovalsGetting Started Electric ServiceImportant Instructions Inspect Stove and ComponentsLocation and Clearances High TemperaturesSelecting Stove Location ClearancesLeg Leveling System Electric Stove Set UpPlug into Outlet Sharp Edges Shock RiskIntensity Switch Main Power SwitchHeater Switch Operating InstructionsIssues Possible Causes Solutions TroubleshootingCleaning Firebox and Control Compart- ment Maintenance and Servicing the FireplaceCleaning Glass Doors and Back Glass Shock Risk Burn RiskReplacing the Light Bulbs When cleaning glass doorReference Materials TiaraE DimensionsWiring Diagram Tiara Service PartsTiara Optional Components Limited Warranty WarrantyContact Information Do Discnot ARD

TiaraE 4035-822 specifications

The Heat & Glo LifeStyle TiaraE 4035-822 is a modern gas fireplace that seamlessly blends elegance with advanced technology, making it an ideal choice for homeowners looking to enhance their living spaces. This innovative fireplace embodies versatility, allowing users to enjoy an alluring flame effect without sacrificing style or functionality.

One of the standout features of the TiaraE 4035-822 is its sleek design, characterized by a contemporary yet timeless appearance. The fireplace features a wide viewing area that showcases a stunning flame, creating a cozy ambiance in any room. With a variety of trim options available, homeowners can customize the look to suit their personal style and interior décor.

The TiaraE 4035-822 is equipped with Heat & Glo's state-of-the-art fire technology, ensuring a powerful and efficient heating experience. Its innovative design includes a high-efficiency burner system that maximizes heat output while minimizing gas consumption. This means users can enjoy the warmth and beauty of a real flame without worrying about excessive energy bills.

Another significant aspect of the TiaraE 4035-822 is its intuitive control system. The fireplace can be operated using a remote control, providing convenience for users who want to adjust the flame height or turn the unit on and off without leaving their seats. Additionally, it features an optional wall control and an app-enabled smart home integration, allowing for even more flexibility and ease of use.

Safety is also a top priority with the TiaraE 4035-822. The unit includes a built-in safety shutoff feature that automatically turns the fireplace off if it detects any irregularities, providing peace of mind for homeowners.

The TiaraE 4035-822 showcases an adjustable flame and an array of decorative media options, including glass, stones, or logs, enabling users to customize the firebed to create their desired aesthetic. This means that the fireplace can be not only a heat source but also a stunning visual focal point in any room.

In summary, the Heat & Glo LifeStyle TiaraE 4035-822 is a thoughtfully designed gas fireplace that combines beauty, efficiency, and modern technology. With its customizable features, intuitive controls, and safety enhancements, it embodies the perfect blend of functionality and style, making it an excellent addition to any contemporary home.
Top Page Image Contents