INSTALLATION
Pre Installation
1.It is mandatory to have a 16 amp.
2. Fixed plumbing is recommended | ||
for the machine. | The water inlet | |
of the machine has a collar | ||
with3/4”parallel | internal | threads. |
The water supply point with an | ||
external 3/4” | parallel | thread |
should be available within1 meter | ||
of the machine’s location. |
| |
WATER |
| MACHINE |
SUPPLY | REDUCER | WATER |
|
| INLET |
STOP |
|
|
LOCK |
|
|
1/2 | 3/4 |
|
3. Two options on the water inlet and |
drain pipe connection are shown. |
In case these possibilities do not |
exist for the drain pipe, please |
arrange an additional length of |
pipe. |
DRAIN |
PIPE |
WATER INLET |
WATER INLET |
DRAIN |
PIPE |
4.Please inform our service centre for installation and demonstration of the machine once the points mentioned above have been completed.
Unpacking
1. Remove Carton.
2. Remove top packing cover.
3. Remove side packing and plastic jacket.
4. Remove packing from the bottom of the
motor
5.Place the machine at the site at which it is to be 
Installed, and put the rat mesh.
7