SECTION 2
CLEANING & MAINTENANCE
IMPORTANT: Make sure the brewer is unplugged before cleaning
Cleaning Drip Tray & External Parts
Regular cleaning of the Brewer’s external com- ponents is recommended using a damp
1.Never immerse the base unit in water or other liquids. The Housing and other exter- nal components may be cleaned with a damp,
2.The Drip Tray can accumulate liquids. The Drip Tray and Drip Tray Plate should be peri- odically inspected and cleaned with a damp soapy
Cleaning the
Holder Assembly
1.Cleaning the Parts
The
K-Cup Holder
Assembly
Funnel
other until it releases. After cleaning, align the
2.Cleaning the Funnel
The Funnel can be removed from the
snaps off. The Funnel is dishwasher safe. To replace it just snap it back onto the
Insert paper clip here to clean out the exit needle
3.Cleaning the Exit Needle
The Exit Needle is located on the inside bot- tom of the
CAUTION: There are sharp needles that puncture the
When finished cleaning, reassemble the
NOTE: Over time, discoloration, spotting or staining may appear in the Hot Water Tank. This is normal and will vary depending on the miner- al content of the bottled or filtered water used in the brewer and will not affect the operation of the brewer.
Cleaning the Hot Water Tank
To access the Hot Water Tank, press the PRESS TO OPEN button and then lower the handle completely, the water fill lid will pop open. Inspect the Hot Water Tank area and clean with a damp lint free cloth as necessary. Close the water fill lid when finished.
3