Keurig B150 owner manual Stopping the Brew Process, Adding Water

SECTION 1 Set-Up & First Brew (continued)

Stopping the Brew Process

If you need to stop the brewing after the process has started, press and release the Power Switch to turn the Brewer ‘OFF’. The flow of coffee, tea or hot cocoa will stop and the heating element and the LCD Screen will shut off.

NOTE: You may get more coffee, tea or hot cocoa in your cup during your next brew. We recommend that you perform a cleansing brew with water only after a terminated brew. Then your next brew will be the volume you have selected.

IMPORTANT: Do not remove the Water Reservoir during the brewing process.

2. Lift off the Water Reservoir Lid and pour

water directly into the Water Reservoir

while it is still attached to the Brewer,

then replace the Lid.

3. The Brewer can also be connected directly into

the water line. To order a B150 Direct Plumb Kit

please call 1.888.CUP.BREW (287.2739).

fig. 9

2. Fill Water Reservoir

Adding Water

The LCD Display of your Brewer will indicate when the water level in the Reservoir is low or if the Water Reservoir has been removed by displaying the words “FILL WATER RESERVOIR” (fig. 9). The Brewer will not allow you to brew when “FILL WATER RESERVOIR” is displayed (fig. 9).

The Water Reservoir can be filled in three ways.

1.Remove the Water Reservoir from Brewer by first removing Lid from the Water Reservoir, then lifting the Water Reservoir straight up and toward the right of the Brewer. Fill with water. Place the Water Reservoir back on the Brewer and replace the Lid.

8