Top Innovations SP-400 owner manual How to Thread the HandyMender, Adjusting the Thread Tension

Page 5
How to Thread the HandyMender

6. Tie off the seam as follows:

How to Thread the HandyMender

Thread the HandyMender following the numbers as shown below.

a. Pass Threader through the last stitch. b. Place the thread into Threader.

c. Pull out about 1 inch.

d. Slip the thread through the loop and pull it tight to finish the seam.

NOTE: Thread should flow from the bobbin or spool as shown: (The spring must be in place before installing bobbin.)

Use threader to pass the thread through needle eye from rear to front.

Adjusting the Thread Tension

If stitching is too tight, turn the tension control nut slightly to the left

If stitching is too loose, turn the tension control nut slightly to the right

9

10

Image 5
Contents Innovative Products to Make Your Life Easier Top Innovations, IncTop Innovations, Inc 400 NW Platte Valley Drive Riverside, MOIncludes the Following Accessories PARTS AND ACCESSORIESTABLE OF CONTENTS Batteries Not IncludedGETTING READY TO MEND IMPORTANT SAFEGUARDSHow to Sew How to Finish the Seam Adjusting the Thread Tension How to Thread the HandyMenderPERFORMANCE CHECKLIST To Install the Normal Thread SpoolNeedle Unthreads When Starting Seam 2.Connect the Spool Pin on Bobbin ShaftThread Comes Out Of Tension Control While Sewing Pressing Power SwitchHandyMender Does Not Run Or Runs Slowly After QUESTIONS?Notes LIMITED WARRANTY400 NW Platte Valley Drive Riverside, MO