Sirius Satellite Radio SIR-GM1 manual Compatibility

CAUTION

This symbol means important instructions. Failure to heed them can result in injury or material property damage.

HALT USE IMMEDIATELY IF A PROBLEM APPEARS. Failure to do so may cause personal injury or damage to the product. Return the unit to your authorized retailer or nearest service center for repairing.

INSTALL THE WIRING SO THAT IT IS NOT CRIMPED OR PINCHED BY SCREWS OR SHARP METAL EDGES. Route the cables away from moving parts or sharp pointed edges. This will prevent crimping and damage to the wiring. If the wiring must pass through a metal hole, be sure to use a rubber grommet to prevent the wire’s insulation from being cut by the metal edge of the hole.

USE THE SPECIFIED ACCESSORY PARTS AND INSTALL THE PRODUCT SECURELY. Be sure to use only the specified accessory parts. Use of non- specified parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose, resulting in hazards or product failure.

USE CAUTION IF YOU NEED TO DISCONNECT THE BATTERY TERMINAL. Please consult the vehicle’s owner’s manual or a service technician prior to removing the battery positive or ground connection, as it may cause damage to the vehicle’s electrical system or require reprogramming of the vehicle’s computer-controlled devices.

COMPATIBILITY

The way the SIR-GM1 is installed and used in your vehicle will vary depending on several factors including the make, model and year of the vehicle as well as the factory-installed options. Please refer to the information below for information on the proper method of SIR-GM1 installation.

If your vehicle is pre-wired for satellite radio, then you should install the SIR- GM1 in the factory satellite radio tuner location using the existing wiring and the ‘factory harness adapter’. Please refer to the factory service manuals for appropriate installation instructions.

If your vehicle is not pre-wired for satellite radio, but it is compatible with the SIR-GM1, then you must use the provided T-harness to connect to the back of your factory headunit.

SIR-GM1 Installation Guide 5