Kenmore 790.3693 Before Setting Surface Controls, Control Locations of the Gas Surface Burners

Before Setting Surface Controls

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates

It is very important to make sure that all of the Surface Burner are installed correctly and at the correct locations.

1.	Remove all packing tape from cooktop area. Remove
	all Burner Caps and Burner Heads.
2.	Discard	all packing material located under Burner
	Heads	(if applicable).
3.	To replace the Burner Heads & Caps, match the
	letters located under center of Burner Caps with the
	letters located inside Burner Heads (Figure 1).
4.	Match Burner Skirts with Burner Heads and Burner
	Caps (see Figure 1). Replace the Burner Heads and
	Caps on cooktop (see Figure 2). Carefully align the

Heads, Surface Burner Caps and Surface Burner Grates

_12.2K T 5K1

B BUper

H4.2K

P

	Electrodes into slot or hole of each Burner Head
	(Figure 3). Note: The Burner Heads should sit flat on
	Cooktop	Burner Skirts.
5.	Place the	removable oven vent cover over the fixed
	oven vent cover.
6.	Unpack Burner Grates and position on the cooktop.

Burner Skirt

Figure 1

Figure 2

_ectrodesmust

REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL

TO ENTER THE GAS ORIFICE HOLDER OPENING.

Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use.

Figure 3 align into slot or hole for each Burner Head

Control Locations of the Gas Surface

Burners

Your range is equipped with gas surface burners with different BTU ratings. The ability to heat food quicker and in larger volumes increases as the burner size increases,

The small SIMMER burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop (see Figure 4).

The STANDARD burner can be used for most surface cooking needs. The standard burner is located at the left front position on the cooktop (see Figure 4).

The POWER burners are best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. The POWER burners are located at the right front and left rear burner positions on the cooktop (see Figure 4).

	Regardless of size, always select cookware that
	is suitable for the amount and type of food being
	prepared. Select a burner and flame size appropriate to
	the pan. Never allow flames to extend beyond the outer
Figure 4	edge of the pan.