Kenmore 5303304549 manual Oven Light, Adjusting Oven Temperature, Instructions

Oven Light

Be sure the range is

unplugged and all parts are COOL before replacing the oven light,,

- Wire Holder

Glass Shield

Adjusting Oven Temperature

Figure I

	7
USE THF._E ARROWS WHEN
ADJUSTING OVEN TEMPERATURE	f
ON NON-SELF CLEANING RANGE&

i .......

The oven light automatically turns on when the door is opened (some models) Use the switch (some models) located on the control panel to turn the light on when the door is closed.

Changing the Oven Light:

The oven light islocated at the rear of the oven, To replace, follow these

instructions:

tTurn power off at the main source or unplug the range, BESUREALL PARTSARECOOL BEFOREREMOVING BULB,

2, Wear a leather-faced glove for protection against possible broken gfass,, 3., Presswire holder to one side to release the glass shield.

4.Replacebulb with a 40 watt appliance bulb

5.Replaceglassshietd in socket and snap wire holder into place,,

6,, Turn power back on at the main source (or plug the range back in)

7., The clock (if equipped) will then need to be reset, SeeSetting the Clock and Minute Timer in this Owner'sGuide,.

The temperature in the oven has been setat the factory.. When first using the oven,

,be sure to follow recipe times and temperatures, if you think the oven is too hot '."or too cool, the thermostat can be adiusted. Before adjusting the knob, test a recipe

by using a temperature set higher or lower than the recommended temperature. The baking resultsshould help you to decide how much of anadjustment is needed. The knob can be adjusted as indicated on the back of the disk.

To Adjust the Oven Temperature:

1,, Check to be sure the Temperature Control knob is in the OFFposition, 2o Pull the knob straight off the shaft,

3_ Loosen the two screws at the back of the disk (Figure 1),

4_ To lower the temperature for a self-cleaning range, turn the disk counter

dock'wise. To raise the temperature for a self-deaning range, turn the disk clockwise.

5.To lower the temperature for a standard range, turn the disk clockwise.

To raise the temperature for a standard range, turn the disk counterdockwise.

6, When the desired adjustment is reached, tighten both screws_

7, To replace the knob, line up the fiat sidesof both the knob and the shaft, Push the knob into place, DO NOT force the Temperature Control knob onto the shaft or you may damage it

lq