Kenmore 362.6278 Oven Heating Elements, Oven Shelves, Oven Light Replacement, Broiler Pan & Grid

Oven Heating Elements

Do not clean the bake element or

the broil element, Any soil will burn off when the elements are heated,

To clean the oven floor, gently lift the bake element° Clean with

warm soapy water,

Oven Shelves

Clean the shelves with an abrasive _, cleanser or scouring pad.,

NOTE; Take the shelves out of the oven before you begin the self-clean cycle or they may discolor.

To make the shelves slide more easily apply a small amount of vegetable oi! or cooking oil to a paper towel and wipe the edges of the oven shelves with the paper towel,,

Oven Light Replacement

(on some models)

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel,

Broiler	Pan & Grid
After broiling, remove the broiler
pan from	the oven, Remove	the
grid from	the pan, Carefully	pour
out the grease from the pan		into	After broiling remove the
a proper	container.,		broiler pan from the oven,

Wash and rinse the broiler pan and grid in hot water with a soap-fitted or plastic scouring pad..

if food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth, being careful not to touch the hot surfaces with your fingers., Soaking the pan will remove burned-on foods,

The broiler pan may be cleaned with a commercial oven cleaner,, If the grid is grey enamel, it can also be cleaned with an oven cleaner.

Both the broiler pan and grid can also be cleaned in the dishwasher,

Do not store a soiled broiler pan and grid anywhere in the range,

How to Remove the Storage Drawer to Clean

Under the Range

To remove the storage drawer:

1.	Pull the drawer	out all the way
2.	Tilt up the front	and remove it,

Be sure to let the light cover and bulb cool completely

To remove the cover:

Wire cover holder

To replace the storage drawer:

t.Insert glides at the back of the

1.Hold a hand under the cover so it doesn't fall when

released. With fingers of the same hand, firmly push back the wire cover holder, Lift off the cover.

Do not remove any screws to remove the cover.,

2.Replace bulb with a 40-watt household appliance bulb,,

To replace the cover:

1.Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place,

2.Connect electdca! power to the range,,

drawer beyond the stop on	C/ean under the range,
range glides°

1Lift the drawer if necessary to insert easily.,

3.Let the front of the drawer down, then push in to close,

12