Kenmore 795.6997, 795.6991, 795.7997 manual Reattaching Freezer Door

RemovetheouterlowerDecorativeScrewfromhousing atareabetweenfreezerandrefrigeratordoors(Fig.31). YouwillneedthisholefortheMiddleHingeBracket).

Fig.31¢}...._:_;

©

•Following illustration, flip the Middle Hinge Bracket (Flange will now be on top) and position on left side of refrigerator and re-attach with two bolts and a Phillips screw. (Fig. 32).

•Place refrigerator door down over pin on bottom hinge. (Fig. 32).

•Place washer between refrigerator door and middle hinge and re-attach Hinge Pin to Hinge Bracket with 1/4-in. socket wrench. NOTE: Bracket has been flipped, but Hinge Pin stays in the same orientation with its hexagonal end facing upward (Fig. 32).

Fig. 32

Bracket

PlaceUpperHinge'sPininthetopoffreezerdoor andlineuptheUpperHingewithholesintopof

refrigerator. Use the 3 bolts to replace Hinge (Fig. 35).

Fig. 35

•Tighten bolts. Force-fit Top Hinge Cover over Top Hinge (Fig. 36).

Fig. 36

•Replace cover from left side of refrigerator top onto the right of top to cover the holes. Cover is also force-fitted (Fig. 37).

Cover (on top of _----_----A_

Place Decorative Screw into outer hole on right side of housing (Fig. 33).

Attach cover on the right side. Cover is force-fitted (Fig. 33).

-_ ..... /J / I I Decorative

€l S_rew

REATTACHING FREEZER DOOR

•Put freezer door down over the Hinge Pin on the Middle Hinge Pin Bracket (Fig. 34).

Fig. 34

After changing doors, make sure that the corners

of the Door Gaskets are not folded over (see Fig. 38). To ensure a good seal, apply a small amount of silicon grease on the corners of gaskets.

Corners

Fig. 38

\/

14