Kenmore 795.7202 manual Performance Data Sheet, ContaminantReduction, Average% Max Effluent, Mg/L

Performance Data Sheet

Model: GENIIO42F-08Use Replacement Cartridge GEN11042FR-08

The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in NSF/ANSI Standard 42.

System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of substances listed below.

	Capacity 500 Gallons (1,892 Liters)							Contaminant Reduction Determined by NSF testing.
ContaminantReduction			Average		Influent Challenge			Average Product	Average%	Max Effluent	Min. Required
			Influent		Concentration			Water Concentration	Reduction	Mg/L	Reduction
Chlorine	Taste and	Odor	2.0	mg/L	2.0	mg/L	_+ 10%	mg/L	97.4%	0.06 mg/L	_>50%
Nominal	Particulate	Class III,	48,000	pts/mL	At least	10,000	particles/mL	7.5 mg/L	99.9%	26 mg/L	_>85%
_>5.0 to < 15.0 tim

Application Guidelines/Water			Supply Parameters
Service Flow		0.5	gpm	(1.89 lpm)
Water	Supply	Potable		Water
Water	Pressure	20 -125	psi (138 - 862 kPa)

Water Temperature 34 °F - 100 °F (1.1°C - 37.8 °C)

It is essential that the manufacturePs recommended installation, maintenance and filter replacement requirements be carried out for the product to perform as advertised.

NOTE: While the testing was performed under standard laboratory conditions, actual performance may vary.

Replacement Cartridge: GEN11042FR-08.
To purchase	a replacement filter,	visit	your local	Sears
store or call	1-800-4-MY-HOME.	Visit	us on the	web at

www.sears.com/partsdirect.

SAFETY INFORMATION

Read, understand, and follow all safety information contained in these instructions prior to use of the KENMORE® Model GEN11042F-08 drinking water system. Retain these instructions for future reference.

Intended Use:

The KENMORE® Model GEN11042F-08 drinking water system is intended for use in filtering contaminants from drinking water as listed on the Performance Data Sheet, and has not been evaluated for other uses. The system is installed inside the refrigerator and must be installed,

operated and maintained as specified in the installation and use instructions.

To reduce the risk associated with ingestion of contaminants:

Do not use with water that is microbiologicatty unsafe or of unknown quality without adequate disinfection before and after the system.

To reduce risk of property damage due to water leakage:

•Read and follow Use Instructions before installation and use of this system.

•Installation and use MUST comply with all state and local plumbing codes.

•Protect filter from freezing, Remove filter in temperatures below 34°F (1.1°C).

•Do not install on hot water supply lines. The maximum operating water temperature of this filter system is 100°F (3Z8°C).

•Do not install if water pressure exceeds 125 psi (862

kPa). If your water pressure exceeds 80 psi (552 kPa), you must install a pressure limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.

•Do not install where water hammer conditions may

occur. If water hammer conditions exist you must install a water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.

•Where a backflow prevention device is installed on a water system, a device for controlling pressure due to thermal expansion must be installed.

•The disposable filter cartridge MUST be replaced

every six months, at the rated capacity or sooner if a noticeable reduction in flow rate occurs.

29