POWER / GROUND and REMOTE
Once you have run both the power and ground wires, it's time to connect the cables to the amplifier. Cut off excess wire and, using wire strippers, strip the ends of the power and ground cables approximately 1/4 inch. Locate the PowerLock power and ground connector (supplied). With a small flat bladed screw driver, loosen the screws before attempting to insert the cables. Insert the wires into the appropriate hole, and tighten the screws. Once the wires are secure, the PowerLock may be plugged into the amplifier. The Power/Ground PowerLock will accommodate 4 gauge wire for the Pro6800.
Power/Ground PowerLock |
|
Power wires | Fastening screws |
| |
Connect to Amplifier |
|
7 |
|
BACK TO CONTENTS