Kenmore 2220698 Removing packaging materials, When Moving Your Refrigerator, Cleaning before use

Page 4

REFRIGERATOR

INSTALLATION

Excessive Weight Hazard

Use two or more people to move and install refrigerator,

Failure to do so can result in back or other injury,

Removing packaging materials

•Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

•Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These

products can damage the surface of your refrigerator. For more information, see the "Refrigerator Safety" section.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it.

Do not wiggle or "walk" the refrigerator when trying to move it, as floor damage could occur.

Cleaning before use

After you remove all of the packaging materials, clean the inside of your refrigerator before using it. See the cleaning instructions in the "Refrigerator Care" section.

Important information to know about glass shelves and covers:

Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use special care when re- moving them to avoid impact from dropping.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator,

Failure to do so can result in death, explosion, or fire,

To ensure proper ventilation for your refrigerator, allow for V2in. (1.25 cm) space on each side and at the top. When installing your refrigerator next to a fixed wall, leave 2 in. (5.08 cm) minimum on each side (depending on your model) to allow for the door to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections.

NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).

,IL

//

1/2" (1.25 cm)

,!

I

2" (5.08 cm) /

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Sears Canada Inc., Toronto, Ontario, Canada M5B 2B8 Sears Roebuck Co., Hoffman Estates, IL 60179 U.S.A2220698 Contents WarrantyRefrigerator Safety Before you throw away your old refrigerator or freezerCleaning before use When Moving Your RefrigeratorRemoving packaging materials To remove the base grille Recommended grounding methodTop Right Hinge Base GrilleDoor Alignment Leveling ScrewHandle Removal optional Door and Hinge ReplacementStyle Connecting to Refrigerator Connecting to Water LineSupply Cold water supplyRefrigerator USE Ensu qngCBeOont sb Adjusting Rotary ControlsIce dispenser £ion S @m Water dispenserDispenser light Dispenser lock on some modelsRefrigerator Mak÷ a// d on!sge B n/BucketRemember To increase ice production rateAc ju@!sb,, e S ipo¢@She f Cnvert b e Ue/Meat D swet Crisper CoversWne Ca Jtt BnOnv@ t b/e @g b/es Meat Humidity control locationRefrigerator Care DooOan and Doo Bns Drop-in Door RailsRefrigerator Control Panel Light @ ang ng tse Light BubsLower Freezer Light Beneath Ice Bin on some models Moving CationAre the doors not closed completely? Close the doors Is the ice maker switch in the OFF right position on Off-taste,odor or gray color in the iceIs the water line shutoff valve to the refrigerator turned Release button on the ice bucket and lift upward. Refer toDispenser water is not cool enough Divider between the two compartments is warmIs the food packaged correctly? Check that all food is Are the pans, shelves, bins, or baskets out of position?Ntse U SAo OanadaWater Certifications Water Treatment Device Certificate NumberEPA Product DataMCL MY-HOME Canada
Top Page Image Contents