Toro 38583, 38584 owner manual Setup, Unfolding the Handle

Page 5

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure

Description

Qty.

Use

 

 

 

 

1.

No parts required

Unfold the handle.

 

 

 

2.

Screws

3

Install the discharge chute.

Chute assembly

1

 

1. Unfolding the Handle

Procedure

1.Loosen the lower handle knobs, pull out the handle bolts until you can move the handle freely, and rotate the handle to the operating position (Figure 3).

Important: Ensure that you do not pinch or kink the control cable or the Quick Shoot™ cables (Figure 5).

Figure 5

1. Control cable

2. Quick Shoot™ cables

Figure 3

1. “U”-shaped handle lock (2) 2. Handle knobs

2.Insert the end of the “U”-shaped handle lock into the open hole in the handle and tighten the handle knobs until they are snug (Figure 4).

Figure 4

5

Image 5
Contents Introduction SafetyPower Clear Snowthrower Operation TrainingPreparation Clearing a Clogged Discharge Chute Maintenance and StorageToro Snowthrower Safety 94-2577 Safety and Instructional DecalsUnfolding the Handle SetupAdjusting the Control Cable Installing the Discharge ChuteProduct Overview OperationStarting the Engine Mixing Gasoline and OilFilling the Fuel Tank Choke lever Stopping the Engine Engaging the Rotor BladesDisengaging the Rotor Blades Preventing Freeze-up after Use Adjusting the Discharge Chute Chute DeflectorOperating Tips MaintenanceRecommended Maintenance Schedules Checking the Control Cable Inspecting the Rotor Blades Servicing the Spark PlugReplacing the Drive Belt Adjusting the Quick Shoot Control Lower cable casing Storing the Snowthrower StoragePage Page Toro 5-Year GTS Starting Guarantee