Murray MX17542LT manual Check Battery See Fig

Page 7

ASSEMBLY

	SEAT	SHOULDER
	SEAT	BOLT
		BOLT
	SEAT PAN
	FLAT WASHER
	LOCK WASHER
		02465
	ADJUSTMENT
	BOLT

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

TERMINAL

TERMINAL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

•Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place gear shift lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Start the engine. After engine has started, move throttle control to idle position.

•Depress clutch/brake pedal into full “BRAKE” position and hold. Move gearshift lever to 1st gear.

•Slowly release clutch/brake pedal and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position.

•Turn ignition key to “OFF” position.

Continue with the instructions that follow.

7

Image 7

Contents Operators Manual General Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Unpack Carton Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport Reverse Operation System ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Before Each USE Maintenance ScheduleLubrication Chart General RecommendationsCheck Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigTransaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig To Install Mower See FigBelt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes Service Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXPage Page Pliez EST Degrés Suivant LESDentretien Remarques Dentretien Remarques Défectueux est Dépannage DE GuideRalenti Moteur EntreposageMoteur Réglages ET RévisionVitesses DE Boîte LA DE Mentgechan CarrossageAVANT/ Roues DES Convergence DI LA DE L’ALIGNEMENT Régler Pour20 .FIG Transmission DE MENTNETRAÎD’ENCourroie LA Remplacer Pour Freins LES Vérifier PourSedeuton Courroie Acer Rempl PourDE Boîtier LE Niveau DE Mettre Pour Tondeuse DE Lame DE MENTNETRAÎD’ENTondeuse LA Enlever Pour Fig la Voir Tondeuse LA Installer PourReglages ET Revision TracteurAIR À Filtre Ligne EN Installé D’ESSENCE FiltreEntretien ’ALLUMAGE Bougie11 .FIG Transmission LA DE RefroidissementLubrification Trapézoïdales CourroiesFig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Utilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauTonte DE Conseils UtilisationMoteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer DE AvantMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirPentes LES Dans Utiliser Pour Accessoires AutresET Charrettes DES Remorquer Pour Tracteur LE Transporter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac E R T O V R E S I L I T U T N E M M O C Fig la Voir Arrêter Pour02829 Moteur Montage LA Voir Rouler Faisant LE EN Ette LA DE Tracteur LE Retirer PourDesmancom DES CON Pour Mentnetionfonc TionsecToncar DU Tracteur LE Sortir PourLE Pour Exigés Outils LES Palette LA DE Tracteur LE Retirer DE AvantSiège Direction de Volant Montar SIN PiezasPente-Guide Clés26-25 Dépannage DE Guide SommaireClient DU Responsabilités Produit DE SpécificationsGénéral Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAUX Imprimé TH 07.25.01