MAINTENANCE
HOW TO REPLACE THE FUSE
If the fuse is blown, the engine will not start. The location of the fuse is next to the battery. Remove the fuse and replace with a automotive fuse (Figure 45).
Automotive Fuse |
Figure 45 |
HOW TO REPLACE THE LIGHT BULB
1.Raise the tractor hood.
2.Turn the light socket until the tabs on the socket align with the notches in the bezel (Figure 46). Remove the light socket. Turn the light bulb and remove the bulb.
3.Install a new light bulb. Align the light socket with the notches in the bezel and turn the light socket to lock in position.
| Bezel |
| Light Bulb |
Light Socket | Figure 46 |
|
HOW TO CLEAN THE MOWER HOUSING
WARNING: Before you clean the mower housing, stop the engine and disconnect the wire to the spark plug.
Grass and other debris on top of the mower housing can keep the belt from working correctly. For safety and correct operation, frequently clean the top of the mower housing. Remove grass and debris from around the pulleys and other moving parts.
1.Move the lever for the blade rotation control to the ENGAGE position.
2.Clean the top of the mower housing.
3.Move the lever for the blade rotation control to the DISENGAGE position.
4.Again clean the top of the mower housing.
5.After you cut the grass, clean the bottom of the mower housing.
STORAGE (over 30 days)
At the end of each year, prepare the unit for storage as follows.
THE ENGINE
For storage information, see the the engine manufacturer’s instructions.
THE BATTERY
1.Remove the battery.
2.Clean the battery terminals of any deposits.
3.Charge the battery. See the instructions on “How To Prepare And Charge The Battery”.
4.Store the battery in a cool, dry place.
NOTE: After a long time in storage, charge the battery.
THE FUEL SYSTEM
WARNING: Do not drain the gasoline inside a build- ing or near a fire. Do not smoke because the fumes from the fuel can cause an explosion.
1.Start the engine.
2.Run the engine until the fuel tank and the carburetor are out of fuel and the engine stops.
3.After storage, make sure you use fresh fuel.
CLEAN THE UNIT
1.Clean the dirt and grass from the engine.
2.Clean the mower housing.
LUBRICATE THE UNIT
See the “Lubrication” instructions in this book.
35 |