ASSEMBLY
IMPORTANT! BEFORE YOU START MOWING
-Check the engine oil.
-Fill the fuel tank with gasoline.
-Check the air pressure of the tires.
-Check the level of the mower housing.
-Make sure the battery cables are attached.
-Make sure the wire is attached to the spark plug.
WARNING: Before doing any assembly or mainte- nance to the mower, remove the wire from the spark plug.
NOTE: In this instruction book, left and right describe the location of a part with the operator on the seat.
HOW TO PREPARE THE ENGINE
NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed.
NOTE: The operation of a new engine will sometimes result in a slight amount of smoke. This smoke is caused by paint or oil on or around the muffler. This is normal and only expected during initial operation.
A separate engine manual is also included with the unit. See this engine manual for the manufacturer’s instructions for the type of gasoline and oil to use. Before you use the unit, read the information on safety, operation, maintenance, and storage.
WARNING: Follow the engine manufacturer’s instructions for the type of gasoline and oil to use. Always use a safety gasoline container. Do not smoke when adding gasoline to the engine. When inside an enclosure, do not fill with gasoline. Before you add gasoline, stop the engine. Let the engine cool for several minutes.
IMPORTANT: This unit is equipped with an internal combustion engine and must not be used on or near any unimproved
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. See an Authorized Service Center for a spark arrester for the muffler.
In some areas, local law requires the use of a resistor spark plug to control the ignition signals. See an Authorized Service Center for a resistor spark plug for the engine.
NOTE: Actual sustained horsepower will likely be lower due to operating limitations and environmental factors.
CHECK THE TIRES
NOTE: The tires were over inflated for shipment. The correct air pressure is shown on the side of the tire.
Check the air pressure in the tires. Tires with too much air pressure will cause the unit to ride rough. Also, the wrong air pressure will keep the mower housing from cutting level. The correct air pressure is shown on the side of the tire.
CHECK THE LEVEL OF THE MOWER HOUSING
Make sure the level of cut is still correct. After you mow a short distance, look at the area that was cut. If the mower housing does not cut level, see the instructions on “How To Level The Mower Housing” in the Maintenance section of this instruction book.
13 |