ASSEMBLY
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are shown at full size.
(A) | (B) |
1001054 | 17x47 |
1.Carefully remove the plastic bag from the seat.
2.Align the holes in the seat hinge to the holes in the seat (Figure 1). Fasten the seat to the seat hinge with the fasteners as shown.
3.Check the operating position of the seat. If the seat needs to be adjusted, loosen the two wing bolts. Slide the seat forward or backward along the seat adjusting holes as shown. Tighten the wing bolts (A).
Seat |
|
Seat Hinge | |
| Seat |
Adjusting Hole | |
B | A |
| |
| Figure 1 |
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steering wheel. Attach the steering wheel as follows:
1.Make sure the front wheels point forward.
2.Look at the hub of the steering wheel. Make sure the locking clip is in place inside the hub.
3.Slide the cover over the steering post (Figure 2).
4.Slide the steering wheel onto the steering post. Push on the steering wheel. The steering wheel will lock onto the steering post. Pull on the steering wheel. Make sure the steering wheel is locked in place.
5.Some models have an decal in the parts bag. Attach the decal to the center of the steering wheel as shown.
Decal | (Optional) |
Steering Wheel | Hub |
| |
| Cover |
Steering Post |
|
| Figure 2 |
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The fasteners are shown at full size.
(A) | (B) | |
31x11 | ||
17x91 | ||
|
1.Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted in the LOW position. To change the position to a higher cutting position, see “How To Adjust The Gauge Wheels” in the Maintenance section.
Axle Bolt
B 
A
Gauge Wheel
Figure 3
11 |