TROUBLE SHOOTING CHART
The Engine will not start.
1.Move the throttle control lever to the FAST or START position.
2.Make sure the fuel tank is filled with clean gasoline. Do not use old gasoline.
3.On a cold engine, push the primer button (optional on some models) five times.
4.Make sure the wire for the spark plug is connected to the spark plug.
5.Adjust the Carburetor. See the “Engine Instruction Book”.
6.There is too much gasoline in the engine cylinder. Remove and dry the spark plug. Put the throttle control in the SLOW position. Pull the
7.The engine is difficult to start in heavy or high grass. Move the mower to a clean dry surface.
8.Make sure the engine stop lever is in the operating position.
9.Make sure the fuel valve is in the ON position. See the “Engine Instruction Book”.
10.On electric start models, make sure the wiring harness is connected. Charge the battery.
The Engine will not stop.
1.Release the engine stop lever.
2.Check the engine stop cable. Replace the cable if bent or damaged.
The Engine performance is bad.
1.Check the height of cut settings. Raise the height of cut if the grass is high.
2.Check the bottom of the blade housing. Clean the blade housing of grass and other debris.
3.Check the wire to the spark plug. Make sure the wire is connected.
4.Clean the engine cooling fins of grass and other debris.
5.Check the carburetor adjustments. See the “Engine Instruction Book”.
6.Check the spark plug gap. Set the spark plug gap at 0.030”.
7.Check the amount of oil in the engine. Fill with oil if necessary.
8.Check the engine air cleaner. See the “Engine Instruction Book”.
9.The gasoline is bad. Drain and clean the fuel tank. Fill the fuel tank with clean gasoline.
10.Check the throttle control. Make sure the lever is not in the CHOKE position.
Excessive Vibration.
1.Remove the blade. Check the blade and balance if necessary. See the blade maintenance instructions.
2.Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE REPLACED.
3.Check the blade adapter. REPLACE A BROKEN BLADE ADAPTER.
4.If the vibration continues, take the mower to an Authorized Service Center.
The grass will not discharge correctly.
1.Clean the bottom of the mower housing.
2.Check for a badly worn blade. Remove and sharpen the blade. For safety, replace the blade every two years with a factory replacement blade.
3.Move the throttle control lever to the FAST position. Check the speed of the engine according to the “Engine Instruction Book”.
The grass is not cut even.
1.Check the height adjustment at each wheel. The height adjustment must be the same for each wheel.
2.Make sure the blade is sharp.
3.Check for a bent or broken blade. A DAMAGED BLADE IS DANGEROUS AND MUST BE REPLACED.
4.Check for a broken blade adapter. REPLACE A BROKEN BLADE ADAPTER.
21