Murray 22" Front Drive Check the Level of CUT, Folding Handle Storage, HOW to Prepare the Mower

Page 22

MAINTENANCE

5.Make sure the blade is balanced. Use a screwdriver and hold the blade parallel to the ground as shown. A blade that is bal- anced will stay parallel to the ground. If the blade is not balanced, the heavy end will rotate toward the ground. Sharpen the heavy end until the blade is balanced.

6.A new blade will cut better than a badly worn blade. Every two years replace the old blade with a factory replacement blade.

CHECK THE LEVEL OF CUT

Test the unit in a small area. If the height of cut is not level or if the cut grass is not discharged, the cause can be: (1) the blade is bent or dam- aged, (2) the blade is not sharp, (3) a worn blade, (4) or a broken blade adapter. Before you use the unit, correct the problem.

FOLDING HANDLE STORAGE

CAUTION: Be careful when you fold or raise the handle. Do not damage the cables. A cable that is bent will not work correctly. Before you use the unit, replace a bent or damaged cable.

How To Fold The Handle

1.Loosen the knobs that hold the upper part of the handle to the lower part of the han- dle. As you fold the handle, make sure the cables are not around the loose fasteners and do not become damaged. Hold the en- gine stop lever in the Operating Position (against the handle). Rotate the upper part of the handle toward the back of the unit (Figure 25) .

2.Loosen the knobs on the lower handle (Figure 26). Push in on the ends of the lower handle. Move the ends of the lower handle past the locking tabs.

3.Rotate the handle forward over the en- gine. Make sure the cables are not dam- aged.

Recoil-Start Rope

Push in on

lower handle.

Figure 25

Lower Handle

Locking

Tabs

Knob

Figure 26

How To Raise The Handle

1.Pull the handle back until the ends of the lower handle lock into position. Tighten the knobs.

2.Hold the engine stop lever in the Operating Position (against the handle). Lift the up- per part of the handle into the operator’s position. Tighten the fasteners that hold the handle.

3.Make sure the recoil-start rope is on the outside of the handle and is not caught be- tween the upper and lower handle.

HOW TO PREPARE THE MOWER

4. Remove the spark plug from the cylinder.

FOR STORAGE

Pour one ounce of oil into the cylinder.

 

Slowly pull the recoil-start grip so that the

WARNING: Do not remove gaso-

oil will protect the cylinder. Install a new

line while inside a building, near

spark plug in the cylinder.

afire, or while you smoke. 5. Clean the dirt and debris from the cylinder

Gasoline fumes can cause an explosion or

 

cooling fins and the engine housing.

a fire.

6.

Clean the bottom of the mower housing.

1.

Drain the fuel tank.

7.

Completely clean the mower to protect the

2.

Let the engine run until it is out of gasoline.

 

paint.

3.

Drain the oil from the warm engine. Fill the

8.

Put the unit in a building that has good ven-

 

engine crankcase with new oil.

22

tilation.

F-050442L

 

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Models MURRAY, INC. Two Year Limited Warranty OWNER’S Information Responsibility of the OwnerGeneral Operation Safe Operation Practices for Walk-Behind MowersII. Slope Operation Use only original equipment or authorized replacement parts IV. ServiceIII. Children They can help you learn. Too often the mow Safe Mowing GuideTices. Read the next few pages carefully Read this Instruction Book. ReadAccessory and the mower Make the clean up after mowing easierAdjustment,except carburetor, while the en Bruises, or even put out an eye. Often the perAuthorized Service Center for your brand Stitutions as service parts. If you need profesSional service, select a shop that is an Mower. If you plan to service the unit yourselfWhen the front of the mower has come up Ufacturer’s recommended replacement partBefore using the grass catcher again Cause. Vibration is generally a warningWhile Mowing Steps to Follow Before MowingAfter Mowing Handle PreparationUnpacking Instructions Remove the washers and axle knobsHandle Handle BracketHigh Position LOW PositionFinal Assembly HOW to Prepare the EngineElectric Start Models Lower the chute deflector Mulcher Plate Removal and InstallationMulching Tips If the quality of cut is marginal, try the followingEngine Stop Lever HOW to Stop the EngineOperation Front Wheel Drive SystemHOW to Start Engine HOW to Operate the MowerHOW to Remove the Battery MaintenanceElectric Start Models HOW to Charge the Battery Battery BracketLubrication Engine MaintenanceHOW to Clean HOW to Adjust Mower Housing Height of CUT Replace the cable if bent or damagedBelt Tension Bolt Drive Belt Belt Tension Bolt Blade Spacer Adjuster NutPulley HOW to Adjust the Drive Cable HOW to Sharpen the Blade Blade ServiceHOW to Remove the Blade Folding Handle Storage HOW to Prepare the MowerCheck the Level of CUT For StorageTrouble Shooting Chart Handle RECOIL-START Models Handle ELECTRIC-START Models Models with Standard Wheels Gear, Pinion 071792 Adapter, Blade 1101968 −Ring 011x16 Models with 14 Rear Wheels −Ring 011x16 Adapter, Blade 1101968 Cover, Dust 071780 Wheels and Tires Wheel Size & Type050442L HOW to Order Repair Parts MURRAY, INC. Lawn Mower Central Parts Distributors

22" Front Drive specifications

The Murray 22" Front Drive mower is designed to provide homeowners with a perfect balance of power, efficiency, and ease of use in lawn care. This versatile machine combines advanced technology with a durable build, making it a popular choice among homeowners looking to maintain their lawns effortlessly.

One of the key features of the Murray 22" Front Drive mower is its reliable 140cc engine. This powerful engine is engineered to deliver sufficient torque and speed, ensuring that it can tackle even tough grass with ease. The front-wheel drive system allows for enhanced maneuverability, making it easier to navigate around garden beds, trees, and other obstacles while maintaining efficiency.

The 22-inch cutting deck is designed for optimal grass cutting performance. It provides a wide cutting path, reducing the number of passes needed to achieve a well-manicured lawn. The deck’s design also supports adjustable cutting heights, allowing users to customize their lawn care to their preferred length. With multiple height settings, this mower is adaptable for various grass types and seasons.

In terms of user comfort, the Murray 22" Front Drive mower features an ergonomic handle that can be easily adjusted to suit the user's height. The design minimizes strain on the arms and back, allowing for extended use without discomfort. The mower also includes a bagging system that efficiently collects clippings, making cleanup easy and reducing the need for raking after mowing.

Safety is a priority with this mower, as it is equipped with a safety blade brake system that stops the blade within seconds of releasing the handle. This feature ensures that users can quickly and safely pause operations, especially when navigating around obstacles or when needing to take a break.

Moreover, the Murray 22" Front Drive mower is designed for easy maintenance. Its lightweight construction makes it easy to transport and store, while the straightforward assembly allows users to set it up in no time. Its sturdy build ensures long-lasting performance, making it a reliable tool for lawn care throughout the seasons.

Overall, the Murray 22" Front Drive mower integrates powerful performance, user-friendly features, and innovative technology to help homeowners achieve a beautiful lawn with minimal effort. Whether for a small or medium-sized yard, this mower proves to be an excellent investment for effective lawn maintenance.
Top Page Image Contents