4
4.Install the guard as shown, snapping it into both sides of the trimmer.
m±5771
Caution
The blade under the guard is sharp and can cut you. Be careful when handling the trimmer so that you do not accidentally cut yourself.
5.Install the metal wire guide.
7.Connect the shoulder strap to the trimmer, if desired.
8.Adjust the strap length by sliding the adjustment buckle to fit you comfortably.
m±6307
Installing the Charger
Mount the charger indoors (such as a garage or other dry place), near a power outlet, and out of reach of children. Ensure that the area is free of clutter and debris. You must also ensure that the charger is high enough so that the trimmer can hang unobstructed below it.
Two wood screws are provided for mounting the charger. If you want to mount the charger on wall board, purchase two wall anchors for the screws.
1.Place the charger against the wall and mark the two hole locations.
m±5783
6.Secure the wire guide with the thumb screw.
m±5784
m±5787
2.Drill pilot holes as follows:
•If installing the charger on wall board, plaster, or cement, drill two holes for the wall anchors (as indicated by the wall anchor manufacturer) at the marked locations.
•If installing the charger on wood, drill two holes, slightly smaller than the diameter of the screw threads, at the marked locations.
3.If installing the charger on wall board, plaster, or cement, insert the two wall anchors into the holes.
4.Hold the charger against the wall and drive the screws into the wall anchors or holes.
3329±341