Tire Pressure
WARNING: Maximum tire pressure under any circumstances is 30 psi. Equal tire pressure should be maintained at all times.
The tires on your unit may be
Attaching The Seat
1.Remove the two knobs from the bottom of seat.
2.Position the shoulder screws (found on the base of the seat) inside the slot openings in the seat pivot bracket.
3.Slide the seat slightly rearward in the seat pivot bracket, lining up the rear slots in the pivot bracket with the remaining two holes in the seat’s base.
4.Select desired position for the seat, and secure with the two knobs removed earlier. See Figure 3.
Knobs |
Shoulder Screws |
Figure 3
Shipping Brace Removal
WARNING: Make sure the riding mower’s engine is off, set the parking brake and remove the ignition key before removing the shipping brace.
•Locate the shipping brace, if present, and warning tag found on the right side of the cutting deck. See Figure 4.
•While holding the discharge chute with your left hand, remove the shipping brace with your right hand by grasping it between your thumb and index finger and rotating it clockwise.
Figure 4
WARNING: The shipping brace, used for packaging purposes only, must be removed and discarded before operating your riding mower.
WARNING: The mowing deck is capable of throwing objects. Failure to operate the riding mower without the discharge cover in the proper operating position could result in serious personal injury and/or property damage.
10