Murray EV3850x4NA manual HOW to Raise the Handle

ASSEMBLY

HOW TO RAISE THE HANDLE

1.Loosen the knobs and raise the upper handle to the upright position. See Figure 2.

2.Tighten the knobs. Make sure the knobs are to the outside of the handles as shown in Figure 2.

3.Insert the end of the control rod, from RIGHT to LEFT, through the hole in the front wheel arm. Attach with hair pin found in parts bag. See Figure 3.

4.Push down on the handle to tilt the unit back.

Knobs

Upper

Handle

Control

Rod

Figure 2

Front

Wheel Arm

Hair Pin

5.Insert the other end of the control rod, from RIGHT to LEFT, through the hole in the depth control lever and fasten with hair pin. See Figure 4.

6.Move the depth control lever forward to the STARTING and TRANSPORT posi- tion.

7.Remove any packing material from the bottom of the unit.

8.To attach the recoil starter rope to the rope guide, twist the recoil starter rope through the rope guide. See Figure 5.

Hairpin

Depth Control

Lever

Control Rod

Figure 4

Rope Guide

Control

Rod

Figure 3

Recoil Starter
Rope	Figure 5

F–041105C 7